708183

Bosch UniversalRotak 36-555 Manual

20
Zoom out
Zoom in
Previous page
1/333
Next page
20 | English
F 016 L81 836 | (07.09.2018) Bosch Power Tools
Temperature Monitoring of the Garden
Product's Electronics
The red LED lights up continuously when pressing the On/
Off switch: The temperature of the garden product's elec-
tronics is below 5 °C or above 75°C.
At a temperature above 90°C, the electronics of the garden
product switch off until the temperature is within the allow-
able operating-temperature range again.
Cutting Capacity (Battery Operating Duration)
The cutting capacity (battery operating duration) depends
on lawn properties, such as grass density, moisture content,
grass length and height of cut.
Switching the machine on and off frequently during cutting
will also reduce the cutting capacity (battery operating dura-
tion).
To improve the cutting capacity (battery operating dura-
tion), it is recommended to cut more frequently, increase
the cutting height and walk at an appropriate pace.
The example below shows the connection between cutting
height and cutting capacity with regard to three batteries.
Cutting Conditions
6cm
4cm
Very thin, dry grass
Cutting capacity
Battery with 2.0Ah up to 250 m
2
Battery with 4.0Ah up to 500 m
2
Battery with 6.0Ah up to 750 m
2
To increase the run time an additional battery can be pur-
chased from an authorised customer service agent for Bosch
garden products.
Troubleshooting
Problem Possible Cause Corrective Action
Motor refuses to start Internal wiring of garden tool defective Contact Bosch customer service agent
Battery discharged Recharge battery
Battery too hot/cold Allow to cool/warm
Grass too long Max. allowed grass height 30cm on highest
height-of-cut setting
Motor protector has activated Allow motor to cool and increase height of cut
Isolator switch not inserted correctly/fully Fit correctly
Garden tool functions
intermittently
Internal wiring of garden tool defective Contact Bosch customer service agent
Motor protector has activated Allow motor to cool and increase height of cut
Machine leaves ragged
finish
and/or
Motor labours
Height of cut too low Increase height of cut
Cutting blade blunt
Replace cutting blade (see figure J)
Possible clogging Switch garden tool off and disengage isolator
switch
Check underneath the garden product and clear
out as necessary (always wear protective gloves)
Blade fitted upside down Refit blade correctly
Blade not rotating
while garden product
switched on
Cutting blade obstructed Switch garden tool off and disengage isolator
switch
Clear obstruction (always wear protective gloves)
Blade nut/bolt loose Tighten blade nut/bolt (22 Nm)
Excessive vibrations/
noise
Blade nut/bolt loose Tighten blade nut/bolt (22 Nm)
Cutting blade damaged
Replace cutting blade (see figure J)
Battery and charger
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch UniversalRotak 36-555 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch UniversalRotak 36-555 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 6,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info