743500
7
Zoom out
Zoom in
Previous page
1/84
Next page
TRZ 12 T/W
7
English
3 Mounting
Before starting work, the voltage supply
(230 V AC) to the heating unit must be in-
terrupted.
3.1 Choosing a Suitable Installation
Location
The installation location should be chosen care-
fully as it can affect the efficiency with which the
room thermostat is able to control the system.
Requirements
The installation room must be suitable for the
temperature regulation of the complete heat-
ing system.
The radiators installed in the room should not
have thermostatic valves mounted.
Note:
It is best to use preset manual valves in
the room in which the room thermostat
is installed. This enables you to set the
radiator temperature as low as possible.
For the mounting location, select an interior
wall, if possible, and take care that neither
drafts or heat radiation (also not from behind,
for example, from ducts, hollow walls, etc.)
can have an effects on the regulator.
There must be sufficient space below the
programmer to allow air to circulate unre-
stricted through the ventilation slots (shaded
area in Figure ).
Note:
Observe the recommended clearances
as shown in Figure .
3.2 Mounting the Regulator Base
loosen the upper part (i) from the base (b)
and pull off (Fig. ).
Fit base (b) to a conventional 55 mm dia.
flush fitting socket box (k) using two screws
(j) (Fig ).
or
Screw base (b) to wall using wall plugs
(6 mm) and screws (dome head, 3.5 mm
dia.) (Fig. , drilling template supplied).
4 Electrical Connection
Protection against contact:
After the
electrical connection, the protective cover
must be mounted again with screws in all
cases.
Observe all applicable regulations.
Remove screw (c) and protective cover (d)
from terminal block (Fig. ).
Connect the room thermostat using wires
rated at least H05VV-.. with the following
cross-sectional areas:
Mains power: 1,5 mm
2
Control circuit: 1,5 mm
2
Wire up programmer as shown in the appro-
priate wiring diagram:
KN/K..-8 E/EC: Fig.
KN..-8 P/KP: Fig.
Heating equipment
with Bosch Eurotronic: Fig.
Other makes: Fig.
Attention:
If the regulator is connected to a KN..-8KP boil-
er, the jumper for the heating circuit pump con-
nection must be removed. This makes intermit-
tent pump operation possible. A detailed de-
scription is contained in the installation
instructions of the KN..-8KP.
Refit protective cover (d) on terminal block
and fix with screw (c).
Fit programmer top section (i) onto base.
Set programmer.
2
2
1
3
4
1
5
6
7
8
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch TRZ 12 W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch TRZ 12 W in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 1,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info