743416

Bosch TR4000 Manual

6
Zoom out
Zoom in
Previous page
1/40
Next page
Operating instructions
6 720 876 041 (2020/06)
6
Congratulations on purchasing this BOSCH appliance.
You have acquired a top-quality product, which will
give you a lot of enjoyment.
2 Operating instructions
2.1 Getting to know your appliance
This appliance is an electronically-regulated, pressurized continuous-
flow heater for decentrally supplying hot water.
The electronic continuous-flow heater heats the water as it flows through
the appliance. One or more taps can be supplied with warm water.
2.1.1 Operating element
1 Status display
2.2 Operating the appliance
2.2.1 Switching the appliance on and off
The continuous-flow heater switches on and heats the water when
the warm water tap is opened. It switches off again if the water tap
is closed.
The factory default setting for the warm water outflow temperature
is 55 °C.
Note: The electronic control unit senses the input water’s temperature
and rate of flow and automatically adjusts the power consumption in
order to obtain the set output water temperature (up to the power limit).
Increasing the water temperature
If the supply water temperature is low and the flow-rate is high, then it
may happen that the set output water temperature is not obtained
because the power limit is exceeded. This is signalled by rapid flashing of
the status display.
• If this happens, then slightly close the warm water tap.
2.2.2 Status display
2.2.3 Startup after power failure
• Open the warm water tap fully and allow water to flow until it is warm.
2.2.4 Using the appliance after switching off the water supply
• Switch off the appliance (unscrew the fuse in the fusebox).
• Open the warm water tap and keep it open until the air has been
completely forced out of the water pipe.
• Switch the fuse back on again.
• Open the warm water tap fully and allow water to flow for at least one
minute.
Only then (for safety reasons) will the appliance begin to heat.
The appliance is now ready to operate.
2.2.5 Winter operation
Note: It is possible in winter that the supply temperature of the water is
reduced and the required outlet temperature is no longer achieved.
• Reduce the water flow at the tap until the desired water temperature
is reached.
3Cleaning
• Only wipe off the appliance using a moist cloth.
• Do not use acidic or abrasive cleaning materials.
• Do not use a steam cleaner.
4Customer Service
We ask you to always provide the BOSCH serial number (SNR/TTNR) of
your appliance when calling in a customer service engineer. You will find
5 A fault, what to do?
CAUTION:
Attention!
Repairs must only be carried out by an authorised technician. Improper
repairs can lead to risk of serious injury to the user.
If your appliance does not operate as required, it is often due to a very
minor problem. Please check whether you can remedy the fault yourself
by using the following guidelines. You will save yourself the costs of an
unnecessary visit by customer service personnel.
5.1 Faults that the customer can troubleshoot himself
LED Appliance status
Off Off
Lights green On
Flashes green (1/s) The set temperature is not obtained; the rate of
water flow is too high for appliance rating
(the appliance has reached the power limit).
See “A fault, what to do?”
Flashes green (2/s) Cold-water rinse-through phase
Flashes red See “A fault, what to do?”
Fault Cause Solution
Water flow-rate is too low The filter in either the water tap or the showerhead is
clogged.
Remove the filter and either clean it or descale it.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch TR4000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch TR4000 in the language / languages: English, German, Dutch, French, Polish, Turkish as an attachment in your email.

The manual is 3,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info