112553
7
Zoom out
Zoom in
Previous page
1/56
Next page
7
Before using your shirt ironer
Adjusting the connection current:
The appliance is plugged in. The shirt ironer is
off and the programme selector switch 4, Fig.
1, is set to “0”. The button band is fully lifted.
Press the and the start/stop buttons in at
the same time and keep them pressed in.
Three sound signals are emitted to confirm
the operation.
Digital screen 5, Fig. 1, displays the current
the appliance is set to.
Press “Start/stop“. The screen displays the
connection current setting. Press the same
button again to change the current.
Three sound signals are emitted to confirm
the operation.
Press when the current you wish to
work at is displayed on the screen; the shirt
ironer switches itself off and the new setting
is stored in the memory.
The ironing time is longer with the 10-Amp
setting.
The 16-Amp setting is recommended for
enhanced performance.
Adjusting the signal
Sound signals are emitted to indicate that a
specific circumstance has taken place in the
programme.
Change in the connection current setting.
End of ironing and airing cycle.
Adjusting the indicator light
The light flashes 10 times when the
appliance is already at its lifted position
when plugged in.
The light flashes 10 times when the
appliance is lifted from its down position
when already plugged in.
The light flashes to remind you to press
the button at the start of use in order to
initiate preheating and thereby reduce shirt
drying time.
The light lights up when the appliance
is working.
The start / stop light and the light light
up when the appliance is blowing air, in any
cycle.
When the appliance is on pause, the start /
stop light flashes for the 30 seconds that
this function lasts.
Adjusting the size
The size of the ironing dummy is based on
European shirt sizes. The size can be
adjusted between sizes 35 and 50. These
sizes coincide with American sizes XS and
4XL. In the case of blouses, sizes 36/38 to
50/52 (S to XXL) can be used.
The ironing dummy can be adapted to
different cuts (e.g. tapering, blouse cuts) by
adjusting the size. This is done by adjusting
the 3 adjustment cords 16, Fig. 2. To adjust
the size, start by adjusting the top cord. The
volume of the ironing dummy cannot be
reduced when inflated.
2 button arm straps are supplied for ironing
short-sleeved shirts, Fig. 3.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch THB 1500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch THB 1500 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 2,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info