Maintenance and cleaning
!
Risk of electric shock
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
Daily cleaning
Each time the appliance is used, coffee
and milk residues accumulate. So the
fully automatic coffee machine should be
cleaned daily to remove them (preferably at
the end of the day).
Always remove any limescale,
immediately. Such residue can cause
corrosion.
Clean the two coffee outlet nozzles 10
with a damp cloth.
Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
Wash all removable parts by hand only.
Rinse out the water tank 13 with water
only.
Remove, empty and clean the trays for
coffee grounds 21 and residual water 22.
Wipe out the inside of the appliance (tray
holders).
Note: If the appliance is cold when switched
on, or if it is switched to “eco” mode after
other words the system cleans itself.
Cleaning the foaming nozzle 9
Important: Clean the foaming nozzle 9
after each use.
Immerse tube 9f into a container with
warm water.
Place an appropriate container under the
foaming nozzle 9.
Press the h
i The appliance will now heat up for
approx. 20 seconds.
When the h button lights up and J
appears on the display, turn the dial 8 to
g/h.
!
Risk of scaldingRisk of scalding
When the dial is set to g/h the nozzle
may sputter a little. Escaping steam is very
hot. Do not touch the foaming nozzle 9 or
aim it at anyone.
Allow about 1 cup of water to run through.
End the process by turning the dial 8
back to
.
Dismantle the foaming nozzle 9 to clean it
thoroughly (Fig. D).
Clean with a caustic cleaning solution and a
soft brush. Rinse and dry all parts
Brewing unit
The brewing unit can be removed for
cleaning (Fig. E).
Press the eco button to start the
automatic rinse cycle.
Turn the power on/off switch 1 to 0.
Open the door 18 to the brewing unit 19.
Hold the red button 19a down and push
the handle 19b up until you hear it
engage.
Grasp the brewing unit 19 by the handle,
remove carefully, and rinse under running
water. Do not use cleaning agents. Do not
place in the dishwasher.
Vacuum the inside of the appliance, or
clean it with a damp cloth.
Reinsert the brewing unit 19 all the way
into the appliance.
Hold the red button 19a down and push
the handle 19b down as far as it goes,
until you hear it engage. The brewing unit
is now secure.
Close the doors of the brewing unit.
