458026

Bosch TA 211E Manual

11
Zoom out
Zoom in
Previous page
1/68
Next page
11
TA 211 E
English
4 Mounting
Before starting work, the voltage supply
(230 V, 50 Hz) to the boiler must be dis-
connected.
4.1 Mounting of the Outdoor Tempera-
ture Sensor AF (Figures and )
The outside temperature sensor AF is intend-
ed for mounting on the surface of an outer
wall.
The following aspects should be observed:
• Between the Northeast and Northwest
sides of the house
• A minimum of 2 m over ground level
• It should not be influenced by windows,
doors, chimneys, direct sunlight or similar
effects (Fig. ).
• In recesses or under balcony and roof over-
hangs are not suitable as mounting loca-
tions (Fig. ).
• If the major occupied rooms of the building
are all located in the same direction, the out-
door sensor can point in that direction.
Notes:
• If the outdoor sensor is mounted on an east
wall, the sensor must be shadowed in the
early morning hours (e. g., by a neighbour-
ing house of a balcony).
Reason: The morning sun disturbs the
heating up of the house after the end of the
reduced night program.
• If the major occupied rooms point in two ad-
jacent directions, mount the outdoor sensor
on the side of the house that has the worst
climatic conditions.
• For the mounting height, the (vertical) cen-
tre of the height heated by the boiler has
proven to the most suitable (H/2 in Fig. ).
To mount, remove the cover (AF
c
with AF
b
)
and attach the sensor housing (AF
a
) with two
screws to the outer wall (Fig. ).
Legend for Figure :
Y/H = Occupied height to be controlled by the
sensor.
= Recommended mounting location
= Alternative mounting location
4.2 Mounting the Regulator (Figures
and )
➀ Pull out the cover (f) at the bottom and re-
move (Fig. ).
➁ Unscrew the screw (g, Fig. ).
➂ Remove the cover (h) forwards.
➃ Pull the blank panel (i) downward and re-
move (Fig. ).
➄ Insert the TA 211 E from below into the
guide rails and slide up until it clicks
(Fig. ).
➅ Insert the plug (k) attached to the regulator
into the intended connector (Fig. ).
4.3 Mounting the Accessories
Mount the time switch, and the mechanical
limiter in accordance with the associated in-
stallation instructions.
5 Electrical Connection
The electrical connection of the regulator has
already been described in Section 4.2.
The following conductor cross sections are to
be used:
Taking the applicable regulations into consid-
eration, the electrical cable used for the con-
nection of the outdoor sensor and the remote
control must be at least type H 05 VV-...
All 24 V lines (measurement current) must be
laid separately from lines carrying 230 V or
400 V so that no inductive effects take place
(Minimum distance 100 mm).
If external inductive influences such as those
caused by power cables, tram lines, trans-
former stations, radio and television equip-
ment, amateur radio stations, microwave
equipment or similar are to be expected,
shielded cable should used for the signal
lines.
3 5
5
5
5
3
5
• From TA 211 E to the outdoor sensor:
Length to 20 m 0.75 mm
2
to 1.5 mm
2
Length to 30 m 1.0 mm
2
to 1.5 mm
2
Length over 30 m 1.5 mm
2
• From TA 211 E to the remote control
(not in UK): 1.5 mm
2
11
15
11
12
13
14
15
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch TA 211E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch TA 211E in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info