en Operating the appliance
26
Switching off the appliance
Short time after the end of the
programme:
1. Open the door.
2. Switch off ON/OFF switch (.
3. Turn off the tap (not applicable if
Aqua-Stop fitted).
4. Remove the utensils when they have
cooled down.
About the Eco drying function:
When Eco drying is activated in the
Eco 50° programme, the door opens
automatically when the programme
ends. This ensures the best possible
drying result. Low amounts of steam
may occur. If you install the appliance
under a worktop, fit the supplied steam
lock * (follow the procedures in the
installation instructions). The steam lock
protects sensitive fitted furniture and
worktops from damage by water vapour.
Before opening the appliance, leave it
to cool down for a while in the
remaining programmes when the
programme ends.
* depending on model
Interrupting the programme
1. Open the door.
2. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
3. To continue the programme, switch
on the ON/OFF switch ( again.
4. Close the door.
Terminating the programme
Terminating the programme
(Reset)
1. Open the door.
2. Press START button ` for
approx. 3 sec.
The numerical display h indicates
‹:‹‚.
3. Close the door.
The programme sequence lasts
approx. 1 min. On the digital display
h is indicated ‹:‹‹.
4. Open the door.
5. Switch off ON/OFF switch (.
6. Close the door.
Changing the programme
When the START button ` has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme
(Reset).
Intensive drying
The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Caution if utensils are delicate!)
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button ` until
•:‹.... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display h displays the
factory setting •:‹….
5. Press programme button # until
the factory set value š:‹‹ is
indicated on the digital display h.