Operating the appliance en
25
Interrupting the programme
1. Open the door.
2. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
3. To continue the programme, switch
on the ON/OFF switch ( again.
4. Close the door.
Terminating the programme
Terminating the programme
(Reset)
1. Open the door.
2. Press START button )"
for approx. 3 sec.
The digital display 8 shows: ‹:‹‚,
the display window )2 indicates:
Program was terminated, Ready in
1 minute.
3. Close the door.
The programme sequence lasts
approx. 1 min. The digital display
8 shows: ‹:‹‹, the display
window )2 indicates: Finished.
4. Open the door.
5. Switch off ON/OFF switch (.
6. Close the door.
Changing the programme
When the START button )" has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme
(Reset).
Intensive drying
The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Caution if utensils are delicate!)
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )" until
•:‹.... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display 8 displays the
factory setting •:‹….
5. Press programme button # until
the factory set value š:‹‹ is
indicated on the digital display 8.
To change the setting,
1. Press the button 3 to switch the
Intensive drying on š:‹‚ or off š:‹‹.
2. Press START button )".
The set value is saved.
3. Close the door.
