en Operating the appliance
20
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button 8 + until the digital
display h jumps to œ:‹‚.
4. Press 8 + or – button until the
displayed time corresponds with your
requirements.
5. Press START button H, timer
programming is activated.
6. To delete timer programming, press
the 8 + or – button until h œ:‹‹
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value ‹:‹‹ is indicated on the numerical
display h.
Switching off automatically
after the end of
the programme *
Switching off automatically after the end of the programme
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the
programme ends (factory setting).
Automatic disconnection
can be adjusted from ˜:‹‹ to ˜:‹ƒ.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button H
until •:‹... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display h displays the
factory setting •:‹….
5. Press programme button # until
the factory set value ˜:‹‚
is indicated on the digital
display h.
To change the setting:
1. Press programme button 3.
Each time the button is pressed, the
set value increases by one level;
when the value of ˜:‹ƒ has been
reached, the display jumps back
to ˜:‹‹ (off).
2. Press START button H.
The set value is saved.
˜:‹‹ Appliance does not switch off
automatically
˜:‹‚ Off after 1 min
˜:‹ƒ Off after 120 min
