English - 4
Retainer flange for
grinding spindle
M 14
An O-ring (plastic
part) is inserted in
the retainer flange 7
around the spigot.
If the O-ring is missing or is damaged, it must
in all cases be replaced (Order No.
1 600 210 039) before the retainer flange 7 is
mounted.
Retainer flange for
grinding spindle
M 10
The retainer
flange 20 can be
used on both sides.
For diamond cutting
discs it must be posi-
tioned on the grind-
ing spindle 4 and
turned through 180°.
The bore of the diamond cutting disc (Ø 20 mm)
must fit the spigot of the retainer flange 20 with-
out any play.
Do not use any reducers or adapters.
☞
After mounting the grinding tool and be-
fore switching on, check that the grind-
ing tool is correctly mounted and that it
can turn freely.
Flap disc
(for M 14 grinder spindle)
Remove the protective guard 5 and mount the
hand protector 11. Place the special retainer
flange 7 (optional extra, Order No.
2 605 703 028) and the flap disc on the grinder
spindle 4. Screw on the clamping nut 9 and
tighten with the two-pin spanner.
Rubber Sanding Plate 12
Remove the protective guard 5 and mount the
hand protector 11.
For mounting, see the illustration page.
Screw on the round nut 14 and tighten with the
two-pin spanner.
Cup Brush 15/Disc brush
(for M 14 grinder spindle)
Remove the protective guard 5 and mount the
hand protector 11.
The grinding tool must be able to be screwed
onto the grinding spindle 4 until it rests firmly
against the grinder spindle flange at the end of
the grinder spindle threads. Tighten with an
open-ended spanner.
(for M 14 grinder
spindle)
Instead of the clamp-
ing nut 9, the quick
clamping nut 10 (op-
tional extra) can be
used. Grinding tools
can be mounted with-
out using tools.
The quick clamping
nut 10 may be used
only for roughing
and cutting discs.
Use only a flawless,
undamaged quick
clamping nut 10.
When screwing on,
take care that the
side with printing
does not point to the
grinding disc. The ar-
row must point to the
index mark 21.
Lock the grinder spindle with the spindle locking
button 3. Tighten the quick clamping nut by force-
fully turning the grinding disc in the clockwise di-
rection.
A properly tightened undamaged, quick clamping
nut can be loosened by hand turning the knurled
ring in the counter-clockwise direction.
Never loosen a tight quick clamping nut with
pliers but use a two-pin spanner. Insert the
two-hole spanner as shown in the illustration.
7
20
Quick Clamping Nut
(Optional Extra)
3
21
10
3
16 • 1 609 929 807 • TMS • 02.05.01
