English - 6
Cutting grinder Stand
With the cutting grinder stand 16 (optional extra),
work pieces of the same length can be cut at an-
gles of 0 to 45°.
When cutting profiles and square pipes, it is best
to start with the smallest cross section.
Cutting Stone
■ The machine must be used only for dry
cutting/grinding.
It is best to work with
a diamond cutting
disc. To ensure
against tilting, the
cutting guide 19
with special protec-
tive vacuuming hood
must be used.
The machine must be operated only with dust ex-
traction. In addition, wear a dust mask.
The vacuum cleaner
must be approved for
the extraction of ma-
sonry dust.
Bosch provides suit-
able vacuum clean-
ers.
Switch on the ma-
chine and place the
front part of the cut-
ting guide on the
workpiece.
Slide the machine with moderate advancing that
is adapted to the material to be worked (Figure).
For cutting especially hard material, e. g., con-
crete with high gravel content, the diamond cut-
ting disc can overheat and become damaged as
a result. This is indicated clearly by a ring of
sparks that rotates with the diamond cutting disc.
In this case, interrupt the cutting process and al-
low the diamond cutting disc to cool by running
frely at no-load speed for a short time.
Noticeable decreasing work progress and a rotat-
ing spark ring are indications of a diamond cutting
disc that has become dull. With brief cuts in an
abrasive material (e. g., chalky sand stone), it
can be sharpened again.
■ Before any work on the machine itself, pull
the mains plug.
☞
For safe and proper working, always keep
the machine and the ventilation slots clean.
In extreme working conditions, conductive
dust can accumulate in the interior of the
machine when working with metal. The
protective insulation of the machine can be
degraded. The use of a stationary extrac-
tion system is recommended in such cases
as well as frequently blowing out the venti-
lation slots and installing a residual current
device (RCD).
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an authorized after-sales
service centre for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2 wire cable.
The wires in the cable are coloured according to
the following code:
Do not
connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine it must be
disposed of safely.
We guarantee Bosch appliances in accordance
with statutory/country-specific regulations (proof
of purchase by invoice or delivery note).
Damage attributable to normal wear and tear,
overload or improper handling will be excluded
from the guarantee.
In case of complaint please send the machine,
undismantled, to your dealer or the Bosch Serv-
ice Centre for electric power tools.
Maintenance and Cleaning
Guarantee
strain relief
live = brown
neutral = blue
To be fitted
by qualified
professional only
18 • 1 609 929 807 • TMS • 02.05.01
