Manual Bosch PPS9A6B90 (page 11 of 12) (English)

746030

Zoom out

Zoom in

1/12

en Cleaning and maintenance

2Cleaning and maintenance

Cl eani ng and mai nt enanc e

Cleaning

Once the appliance is cool, use a sponge to clean it

with soap and water.

After each use, clean the surface of the respective

burner parts once they have cooled down. If any

residue is left (baked-on food, drops of grease etc.),

however little, it will become stuck to the surface and

more difficult to remove later. The holes and grooves

must be clean for the flame to ignite properly.

The movement of some pans may leave metal residue

on the pan supports.

Clean the burners and pan supports using soapy water

and scrub with a non-wire brush.

If the pan supports are fitted with rubber rests, ensure

that these are also cleaned. The rests may come loose

and the pan support may scratch the hob.

Always dry the burners and pan supports completely.

Water droplets or damp patches on the hob at the start

of cooking may damage the enamel.

After cleaning and drying the burners, make sure the

burner caps are correctly positioned on the diffuser.

Caution!

■ Do not remove the control knobs when cleaning the

appliance. The appliance may be damaged if

moisture finds its way inside.

■ Do not use steam cleaners. This could damage the

hob.

■ Never use abrasive products, steel scourers, sharp

implements, knives, etc. to remove bits of hardened

food from the hob.

■ Do not use knives, scrapers or similar implements to

clean the point where the glass meets the burner

trims, the metal frames or the glass/aluminium

panels, if fitted.

■ Do not put the burner components in the

dishwasher.

Maintenance

Always clean off any liquid as soon as it is spilt. This will

prevent food remains from sticking to the hob surface

and you will save yourself any unnecessary effort.

Never slide pans across the glass surface, as you may

scratch it. In addition, try not to drop heavy or sharp

objects on the glass. Never strike any part of the hob.

Grains of sand that may come from cleaning fruits and

vegetables will scratch the glass surface.

Melted sugar, or foods which contain a lot of sugar

which may have spilt, should be cleaned off the hob

immediately, using the glass scraper.

3Trouble shooting

Tr oubl e shoot i ng

Sometimes certain faults detected can be easily

resolved. Before calling the Technical Assistance

Service, bear in mind the following advice:

Fault Possible cause Solution

The general electrical system

is malfunctioning.

Defective fuse. Check the fuse in the main fuse box and change it if it is

damaged.

The automatic safety switch or circuit breaker has

tripped.

Check the main control panel to see if the automatic safety

switch or circuit breaker has tripped.

The automatic switching on

function does not work.

There may be food or cleaning products stuck between

the ignition sparkers and the burners.

The space between the ignition sparker and the burner

must be clean.

The burners are wet. Dry the burner caps carefully.

The burner caps are not correctly positioned. Check that the burner caps are correctly positioned.

The appliance is not earthed, is poorly connected or the

earthing is faulty.

Contact the installation technician.

The burner flame is not uni-

form.

The burner components are not correctly positioned. Correctly place the parts on the appropriate burner.

The grooves on the burner are dirty. Clean the grooves on the burner.

The gas flow is not normal or

there is no gas.

The gas supply is blocked by gas taps. Open all gas taps.

If the gas is supplied from a gas cylinder, check that it is

not empty.

Change the gas cylinder.

Customer service en

4Customer service

Cus t omer ser vi ce

When contacting our customer service, please provide

the product number (E-Nr.) and production number (FD)

of the appliance. This information is given on the

specifications plate located on the lower section of the

hob and on the label in the user manual.

Please find the contact data of all countries in the

enclosed customer service list.

To book an engineer visit and product advice

Rely on the professionalism of the manufacturer. You

can therefore be sure that the repair is carried out by

trained service technicians who carry original spare

parts for your appliances.

Warranty conditions

In the unlikely event that the appliance is damaged or

does not meet your expectations in terms of quality,

please inform us as soon as possible. For the warranty

to be valid, the appliance must not have been tampered

with, or used inappropriately.

The applicable warranty conditions are those set out by

the company's representative office in the country of

purchase. Detailed information is available from retail

outlets. Proof of purchase must be presented to obtain

the benefits of the warranty.

We reserve the right to introduce changes.

7Environmental protection

Envi r onment al pr ot ect i on

If the ) symbol is shown on the specifications plate,

bear in mind the following instructions:

Environmentally-friendly disposal

Dispose of packaging in an environmentally-friendly

manner.

The packaging of your appliance has been

manufactured using only the materials which are strictly

necessary to guarantee efficient protection during

transport. These materials are 100% recyclable, thus

reducing the environmental impact. You can also

contribute to caring for the environment by following the

advice below:

■ Dispose of the packaging in the appropriate

recycling bin.

■ Before you get rid of an old appliance, make sure

you disable it. Contact your local authority to find out

the address of your nearest recycling centre to

dispose of your appliance.

■ Do not pour used oil down the sink. Collect it in a

sealed container and take it to an appropriate

collection point or, failing that, place it in the rubbish

bin (it will end up in a controlled dump; this is

probably not the best option, but it will avoid

contaminating ground water).

The kitchen smells of gas. A gas tap has been left on. Turn off the taps.

Incorrect coupling of gas cylinder. Check that the coupling is sound.

Possible gas leak. Shut off the gas supply, ventilate the premises and imme-

diately notify an authorised installation technician to check

and certify the installation. Do not use the appliance until

ensuring that there is no gas leak in the installation or

appliance itself.

The burner immediately

switches off after releasing the

control knob.

The control knob was not held down for long enough. Once the burner is on, hold the control knob down a few

seconds longer.

The grooves on the burner are dirty. Clean the grooves on the burner.

Fault Possible cause Solution

GB 0344 892 8979

Calls charged at local or mobile rate.

IE 01450 2655

0.03 € per minute at peak. Off peak 0.0088 €

per minute.

This appliance is labelled in accordance with

European Directive 2012/19/EU concerning

used electrical and electronic appliances

(waste electrical and electronic equipment -

WEEE). The guideline determines the

framework for the return and recycling of used

appliances as applicable throughout the EU.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bosch PPS9A6B90 in the language / languages: English as an attachment in your email.

The manual is 2,04 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch PPS9A6B90

Bosch PPS9A6B90 User Manual - German - 32 pages

Bosch PPS9A6B90 User Manual - Dutch - 12 pages

Bosch PPS9A6B90 User Manual - French, Italian - 32 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bosch PPS9A6B90 Manual

Product: