774953
59
Zoom out
Zoom in
Previous page
1/108
Next page
秤重器 zh-tw
59
要求
¡攪拌碗已插入。
¡所需的工具已插入。
1. 將配料添加至攪拌碗內。
2. 按下釋放按鈕,然後將旋轉臂向下
壓,直至其卡入到位。
3. 將攪拌碗蓋蓋上。
→
「蓋上攪拌碗蓋」
,
頁次
58
4. 插上電源插頭。
5. 將旋轉開關調至所需的速度。
→ 17
6. 將配料處理至所需程度。
7. 將旋轉開關調至
→ 18
等到本機完全停止運行。
8. 拔除電源插頭。
建議
¡可在處理期間變更速度或中斷處理程
序。
¡使用後應立即清潔所有零件,以免殘
留物變乾。
續加配料
1. 處理期間將配料添加到蓋上的進料管
內。
→ 19
2. 如需續加大量食材,請將旋轉開關調
等到本機完全停止運行。
3. 將攪拌碗蓋取下。
→
「取下攪拌碗蓋」
,
頁次
58
4. 將配料添加至攪拌碗內。
5. 將攪拌碗蓋蓋上。
→
「蓋上攪拌碗蓋」
,
頁次
58
6. 將配料處理至所需程度。
使用點動脈衝功能
1. 將旋轉開關調至 段固定不動。
→ 20
a食材便會以最高速處理。
2. 放開旋轉開關。
→ 21
a旋轉開關會自動跳至
a處理程序停止,傳動器隨即自行歸
位。
提示
點動脈衝特別適合以下配件使用:
¡玻璃攪拌機器皿
¡多功能研磨配件組
¡多功能食物處理器
7.10 傳動器保護蓋
如需使用傳動器 2 3 上的配件,應
取下保護蓋。
取下傳動器保護蓋
1. 將標記 處的傳動器 2 保護蓋向
下壓並將其取下。
→ 22
2. 將傳動器3 保護蓋向上拉並將其取
下。
→ 23
安裝傳動器保護蓋
1. 將傳動器2 保護蓋向後與標記
對齊、蓋上並加以壓緊。
→ 24
2. 蓋上並壓緊傳動器3 保護蓋。
→ 25
標記 必須彼此對齊。
注意事項:務必用保護蓋蓋住未使用的
傳動器。
秤重器
8 秤重器
秤重器
您的機器配備秤重器。可將配料單獨秤
重。
主機在腳座上配備 4個重量感應器。
以下因素可能會使量測結果錯誤:
¡腳座未妥當放置於流理台上。
¡流理台出現震動
¡主機下有東西
¡低於 5g 0.01lb的配料量
¡移動主機
¡觸碰主機
¡主機上有東西
8.1 秤重器顯示值
使用秤重器時請注意以下數值。
59


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch MUM5XW40G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch MUM5XW40G in the language / languages: English as an attachment in your email.

The manual is 10.04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info