700702
12
Zoom out
Zoom in
Previous page
1/110
Next page
12
en Cleaning
Caution!
The bottom of the receptacle you use must
not have any bumps or steps in it.
Ŷ Clean all parts before using for the first
time.
X Fig. B
Ŷ Completely unwind the mains cable.
Ŷ Place the blender foot on the base unit
and lock into position.
Ŷ Plug the mains plug into the mains.
Ŷ Place the food in the blender jug or
another tall receptacle.
The appliance works better if there is some
liquid in the ingredients.
W Risk of electric shock!
Only immerse the blender foot into the food
as far as the marking Í or there will be
a risk of electric shock!
Ŷ Set the required speed with the speed
control (Fig. B-5). It is recommended
using a low speed setting for liquids,
hot food and for mixing (e.g. muesli
into yoghurt). The high speed settings
are recommended for processing more
solid foods.
Ŷ Firmly hold the hand blender and jug.
Ŷ Switch on the hand blender by pressing
the required On button.
When switching on the hand blender
, hold it
at a slight angle to prevent it from „sticking“
to the bottom of the blender jug. The hand
blender remains switched on as long as the
On button is pressed.
To prevent the ingredients from splashing,
do not press the On button until the blender
foot has been immersed in the ingredients.
Always switch off the hand blender before
taking it out of the ingredients.
Ŷ Release the On button after processing.
After using the appliance:
Ŷ Pull out the mains plug.
Ŷ Press the release buttons and remove
the blender foot from the base unit.
Cleaning
The appliance must be thoroughly cleaned
after each use.
Important information
The appliance requires no maintenance.
Thorough cleaning protects the appliance
from damage and keeps it functional.
W Risk of electric shock
Never immerse the base unit in liquids and
do not clean in the dishwasher. Before
cleaning the appliance, pull out the mains
plug! Do not steam-clean the appliance!
Caution!
Surfaces may be damaged. Do not use
abrasive cleaning products.
Note: The plastic parts may become
discoloured when processing certain
ingredients such as red cabbage or carrots,
however this can be removed with a few
drops of cooking oil.
Ŷ Pull out the mains plug!
Ŷ Wipe the base unit with a damp cloth
and then wipe dry.
Ŷ The blender jug and lid can be cleaned
in the dishwasher.
Ŷ Clean the blender foot in the dishwasher
or with a brush under running water.
Ŷ Dry the blender foot in an upright
position (blender blade face up) so that
any trapped water can run out.
Note:
Appliances with a spiral cable:
Never wind the cable round the appliance!
Troubleshooting
Problem
Appliance switches off during use.
Remedy
The overload protection device is activated.
Ŷ Switch off the appliance and pull out the
mains plug.
Ŷ Leave the appliance to cool down for
approx. 1 hour in order to deactivate
the overload protection device.
Ŷ Switch the appliance on again.
If the fault cannot be eliminated, please
contact customer service.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch MSM87140 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch MSM87140 in the language / languages: All languages as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info