778944
11
Zoom out
Zoom in
Previous page
1/112
Next page
11
en

Before using for the
first time
Before the new appliance can be used,
this must be fully unpacked, cleaned and
assembled. To do this, perform the following
steps:
1. Remove the motor unit, glass carafe
and all accessories from the packaging.
2. Remove the packaging material that is
present.
3. Check all parts for completeness.
X Fig. A / B
4. Inspect all parts for visible damage.
Caution!
Never operate a damaged appliance!
5. Thoroughly clean and dry all parts
before using for the first time.
X “Care and daily cleaning” see
page 12
Preparing the citrus press
and glass carafe
X Fig. C
1. Insert the collecting tray into the motor
unit.
Caution!
Inspect the discharge valve before inserting
the collecting tray. It must not be blocked by
a foreign object.
2. Place the filter insert into the collecting
tray and rotate until it clicks into place.
3. Position the pressing cone on the drive
shaft.
W Risk of electric shock!
Never manually move the pressing cone/
drive shaft.
The citrus press is prepared.
4. Place the glass carafe on the saucer.
Note: Always use the saucer. This provides
anti-slip protection and noise reduction.
5. Place the prepared citrus press onto the
glass carafe until the opening is sealed
tight.
The citrus press is prepared for use with the
glass carafe.
Operation
Using the citrus press with
the glass carafe
X Fig. D
Use the citrus press with the glass carafe
in order to press larger quantities of juice,
such as freshly squeezed orange juice.
Caution!
The juice is collected in the glass carafe.
The volume capacity of the glass carafe is
1.0 l. End the pressing procedure before the
juice reaches the bottom edge of the motor
unit.
1. Position the prepared citrus press with
glass carafe on a stable and level work
surface.
2. Connect the mains cable to the socket.
3. Position the halved citrus fruits with the
cut surface on the pressing cone and
press down.
The citrus press starts running once the
pressed product is pressed onto the
pressing cone. The pressing cone rotates
either clockwise or anticlockwise. Once the
pressed product is released and pressed
once again, the pressing cone changes
its rotation direction. If excess pressure
is applied, the pressing cone changes
the rotation direction in rapid succession.
Reduce the pressure until the pressing
cone rotates normally once more.
Caution!
Press a maximum of 10 fruits (approx. 2 kg)
one after the other. Then halt the pressing
procedure until the motor unit has once
again reached room temperature. Only then
should the pressing procedure be resumed.
Notes:
To obtain the largest amount of juice,
the pressing procedure should be
repeated a few times.
The filter insert with the rough peel and
the seeds should be emptied if required.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch MCP72GPW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch MCP72GPW in the language / languages: All languages as an attachment in your email.

The manual is 2.84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info