en
26
Water connection
The water may be connected only by
a competent fitter according to the local
regulations of the appropriate water
supply company.
The tap must be near the appliance and
also freely accessible following
installation of the appliance.
The enclosed hose set is 2 metres long.
ã=Caution
Use only the enclosed hose set or
a hose set purchased from customer
service for connection to the drinking
water mains.
Do not use existing or already used hose
sets.
Connect the appliance to a drinking
water line only:
■ Minimum pressure: 0.2 Mpa (2 bar)
■ Maximum pressure: 0.8 Mpa (8 bar)
■ Pressure over 0.8 MPa (8 bar): install
a pressure limiter between drinking
water connection and hose set
Note
The maximum outside diameter
of the water mains (without connecting
pieces) is 25 mm.
Electrical connection
The socket must be near the appliance
and also freely accessible following
installation of the appliance.
The appliance complies with the
protection class I. Connect the appliance
to 220–240 V/50 Hz alternating current
via a correctly installed socket with
protective conductor. The socket must
be fused with a 10 to 16 A fuse.
For appliances operated in non-
European countries, check whether the
stated voltage and current type match
the values of your mains supply. This
information can be found on the rating
plate. Fig.
ã=Warning
Never connect the appliance
to electronic energy saver plugs.
Our appliances can be used with mains
and sine-controlled inverters. Mains-
controlled inverters are used
for photovoltaic systems which
are connected directly to the national
grid. Sine-controlled inverters must be
used for isolated applications (e.g. on
ships or in mountain lodges) which are
not connected directly to the national
grid.
