Manual Bosch Kiox BUI330 (page 19 of 64) (English, German, Dutch, French, Italian)

733030

Zoom out

Zoom in

1/64

– With the on-board computer inserted, push the on/off

button on the eBike battery (bicycle manufacturer-spe-

cific solutions are possible when there is no access to the

battery on/off button; see the battery operating instruc-

tions).

The drive is activated as soon as you start pedalling (except

if you are using the push-assistance function or if the assist-

ance level is set to OFF). The motor output depends on the

settings of the assistance level on the on-board computer.

As soon as you stop pedalling when in normal operation, or

as soon as you have reached a speed of 25/45km/h, the

eBike drive switches off the assistance. The drive is automat-

ically reactivated as soon you start pedalling again and the

speed is below 25/45km/h.

The following options are available for switching off the

eBike system:

– Briefly press the on/off button (4) of the on-board com-

puter.

– Switch off the eBike battery using its on/off button (bi-

cycle manufacturer-specific solutions are possible when

there is no access to the battery on/off button; see the bi-

cycle manufacturer operating instructions).

– Remove the on-board computer from its holder.

If no power is drawn from the eBike drive for about

10minutes (e.g. because the eBike is not moving) and no

button is pressed on the on-board computer or the operating

unit of the eBike, the eBike system, and therefore also the

battery, will switch off automatically to save energy.

Power supply of the on-board computer

If the on-board computer is in the holder (5), a sufficiently

charged eBike battery is inserted into the eBike and the

eBike system is switched on, then the on-board computer

battery is powered by the eBike battery.

If the on-board computer is removed from the holder (5),

the power is supplied by the on-board computer battery. If

the on-board computer battery's charge is running low, a

warning message appears on the display.

To charge the on-board computer battery, slide the on-board

computer back onto the holder (5). Note that if you do not

charge the eBike battery straight away, the eBike system will

automatically switch off after 10 minutes of inactivity. If this

happens, the on-board computer battery will also stop char-

ging.

You can also charge the on-board computer via the USB

port. To do this, open the protective cover (17). Use a Mi-

cro-USB cable to connect the USB port (6) on the on-board

computer to a commercially available USB charger (not in-

cluded with the product as standard) or to the USB port of a

computer (max. 5 V charging voltage; max. 500 mA charging

current).

If the on-board computer is removed from the holder (5), all

values for the functions are saved and can still be scrolled

through.

If the Kiox battery is not recharged, the date and time will be

retained for up to six months. When the on-board computer

is switched on again, the date and time will be reset if a

Bluetooth® connection to the app has been established and

the smartphone has successfully identified the current loca-

tion via GPS.

Note: The Kiox only charges while it is switched on.

Note: If the Kiox is switched off during charging via a USB

cable, the Kiox can only be switched on again once the USB

cable has been disconnected.

Note: To maximise the lifespan of the on-board computer's

battery, it should be recharged for one hour every three

months.

Storage mode/resetting the Kiox

The on-board computer has an energy-saving storage mode

which minimises the rate at which the internal battery dis-

charges. Setting to this mode erases the date and time.

This mode can only be activated by pressing and holding the

on/off button(4) of the on-board computer for at least eight

seconds.

If the on-board computer does not start when the on/off but-

ton(4) is pressed briefly, the on-board computer is in stor-

age mode.

You can deactivate storage mode by pressing the on/off but-

ton(4) for at least two seconds.

The on-board computer detects whether it is in a fully func-

tional condition. If you press and hold the on/off button(4)

for at least eightseconds while in a fully functional condition,

the on-board computer will go into storage mode. If, con-

trary to expectations, the Kiox is not in a fully functional con-

dition and cannot be operated, pressing and holding the on/

off button(4) (for at least eightseconds) will reset it. After

being reset, the on-board computer will restart automatically

after approx.fiveseconds. If the Kiox does not restart, press

the on/off button(4) for twoseconds.

To reset the Kiox to its factory settings, select <Settings>→

<Sys settings>→ <Factory reset>. All user data will be

lost.

Battery charge indicator

The battery charge indicator of the eBike batteryd (see

"Start page", pageEnglish–6) can be read on the status

page and in the status bar. The eBike battery's state of

charge is also indicated by the LEDs on the eBike battery it-

self.

Colour of the

indicatord

Explanation

White The eBike battery is over 30% charged.

Yellow The eBike battery is over 15% charged.

Red The capacity for assisting the drive has been

used up, and assistance is switched off. The

remaining capacity will be provided for the

bike lights and the on-board computer.

If the eBike battery is being charged on the wheel, a corres-

ponding notification will be displayed.

If the on-board computer is removed from the holder(5),

the state of charge that was last displayed for the battery is

saved.

English – 3

Bosch eBike Systems 1 270 020 XBK | (12.03.2019)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Kiox BUI330 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,83 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bosch Kiox BUI330 Manual

Product: