765100
27
Zoom out
Zoom in
Previous page
1/92
Next page
en
27
Installing the appliance
Transporting
Theapplianceisheavy.Secureinpositionduring
transportation and installation.
Due to the weight/dimensions of the appliance and
to minimise the risk of injury and damage to the appli
ance at least two persons are necessary to set-up the
appliance safely.
Removing the appliance doors
If the appliance will not fit through the house door,
theappliancedoorscanbeunscrewed.
Caution!
Only Customer service may unscrew the appliance
doors.
Installation location
Install the appliance in a dry, well ventilated room. The
installation location should neither be exposed to direct
sunlight nor near a heat source,e.g.acooker,radiator,
etc. If installation next to a heat source is unavoidable,
use a suitable insulating plate or observe the following
minimum distances to a heat source:
Ø3 cm to electric or gas cookers.
Ø30 cm to an oil or coal-fired cooker.
If installing the appliance next to another refrigerator or
freezer, ensure a minimum lateral distance of 25 mm
to prevent the formation of condensation.
If a panel or cupboard is installed above the appli
ance, ensure that a gap of 30 mm is left so that the
appliance can be pulled out of the recess if required.
The air heated on the rear side of the appliance must
be allowed to escape unhindered.
Subsurface
Caution!
Theapplianceisveryheavy.
The floor of the installation location must not give way;
if required, reinforce floor.
To ensure that the doors can open all the way, observe
lateral minimum distances when installing the appliance
inacornerorrecess
(~chapter “Installation dimensions”).
If the depth of the adjacent kitchen equipment is more
than 60 cm, observe lateral minimum distances in
order to utilise the full door opening angle
(~chapter “Door opening angle”).
Observe ambient temperature and
ventilation
Ambient temperature
The climate class can be found on the rating plate. The
climate class indicates within which ambient temperat
ures the appliance can be operated. The rating plate
is located in the refrigerator compartment at the right
side.
Climate class Permitted ambient temperature
SN +10 °C to 32 °C
N+16 °C to 32 °C
ST +1Cto3C
T+16 °C to 43 °C
Note:
The appliance is fully functional within the room
temperature limits of the indicated climatic class.
If an appliance of climatic class SN is operated at
colder room temperatures, the appliance will not be
damaged up to a temperature of +5 °C.
Ventilation
In order to improve efficiency of the cooling system and
save energy, it is necessary to maintain good ventila
tion around the appliance for the dissipation of heat.
For this reason, sufficient clear space should be avail
able around the refrigerator. Suggest: It is advisable for
there to be 50-70 mm of space from the back to the
wall, at least 100 mm from its top, at least 100 mm
from its side to the wall and a clear space upfront
to allow the freezer door to open 130° and the
refrigerator door to open 135°.
100 mm
1787 mm
100 mm
100 mm
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch KAI93VIFP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch KAI93VIFP in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 7,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info