665303
57
Zoom out
Zoom in
Previous page
1/137
Next page
en
57
Rectifying minor faults yourself
Before calling After-sales Service:
Check whether you can rectify the fault yourself by using the notes below.
You must pay the cost of the After-sales Service call out even during the guarantee period.
Appliance
Ice-maker
Problem Possible cause Remedy
Appliance is not cooling/
freezing.
The lighting is not working.
The display does not light up.
Power cut. Check whether there is power to the
appliance.
Circuit-breaker is switched off. Check circuit-breaker.
Power plug not properly plugged in. Check whether power plug is properly
plugged in.
The refrigeration unit switches
on with increasing frequency
and for longer periods.
The appliance door is being opened
frequently.
Do not open the appliance door
unnecessarily.
The ventilation openings are covered. Remove any obstructions.
Placing large quantities of food in the
appliance.
Switch on fast cooling/fast freezing function.
The fridge compartment/
freezer compartment is too
cold.
The temperature setting is too low. Set a higher temperature.
The (LED) lighting does not
work.
The LED lighting is faulty. See section headed Lighting (LED).
Light switch is sticking. Check whether you can move the light
switch.
The appliance door was opened for
too long.
The lighting switches off after
approx. 10 minutes.
After closing and opening the appliance
door, the lighting is switched on again.
Unpleasant smells are
noticeable.
Strongly smelling food not packed in
air-tight containers.
Clean the appliance. Pack strongly smelling
food in air-tight containers (see section
headed Smells).
Warning beeper sounds or
temperature indicator flashes.
It is too warm in the fridge or
freezer compartment. Food is
at risk.
Appliance door is open. See section headed Alarm functions.
Too much food was stored at once.
Fresh food compartment (if
existing) does not cool.
Disconnect the appliance from the
mains (power failure or power plug
pulled).
Reset the desired temperature.
Problem Possible cause Remedy
Ice-maker not working. Ice-maker is not connected to the
power supply.
Call After-sales Service.
Ice-maker is not receiving a supply of
water.
Make sure that the water supply is properly
connected.
The temperature in the freezer
compartment is too high.
Check the freezer compartment temperature
setting and set it slightly colder if necessary.
Ice-maker is not making
enough ice or the ice is
misshapen.
Appliance or ice-maker has only been
switched on for a short time.
It takes roughly 24 hours for ice production
to start.
A large quantity of ice has been
dispensed.
It takes roughly 24 hours for the ice-cube
container to be refilled.
Low water pressure. The appliance should only be connected to
a water supply with the specified pressure
(see section headed Connecting the
appliance, subheading Water connection).
Water filter clogged or used up. Replace water filter.
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch KAD90VI30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch KAD90VI30 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info