329042
33
Zoom out
Zoom in
Previous page
1/120
Next page
English 30
Service
Before Calling Service
Troubleshooting Chart
Oven Problem Possible Causes and Suggested Solutions
Oven door is locked and will not open,
even after cooling.
Turn the oven off at the circuit breaker and wait five minutes. Turn breaker
back on. The oven should reset itself and will be operable.
Oven is not heating. Check circuit breaker or fuse box to your house. Make sure there is proper
electrical power to the oven. Be sure oven temperature has been selected.
Oven is not cooking evenly. Refer to cooking charts for recommended rack position. Check "Getting the
Most Out of Your Appliance" for tips and suggestions.
Baking results are not as expected. Refer to cooking charts for recommended rack position. Check "Getting the
Most Out of Your Appliance" for tips and suggestions. Adjust oven
calibration if necessary. See "Oven Temperature Offset" under "Customer
Settings".
Food takes longer to cook than expected. The oven is carefully calibrated to provide accurate results. However, the
temperature can be offset if food is consistently too brown or too light. See
"Oven Temperature Offset" under "Customer Settings".
Food is overcooked. The oven is carefully calibrated to provide accurate results. However, the
temperature can be offset if food is consistently too brown or too light. See
"Oven Temperature Offset" under "Customer Settings".
Convection Bake results are not as
expected.
The oven temperature must be manually reduced by 25 ºF. Refer to
cooking charts and tips for rack positions, cooking times and pan selection.
Adjust oven calibration if necessary. See "Oven Temperature Offset" under
"Customer Settings".
Oven temperature is too hot or too cold. The oven thermostat needs adjustment. See "Oven Temperature Offset"
under "Customer Settings".
Oven light is not working properly. Replace or reinsert the light bulb if loose or defective. Touching the bulb
with fingers may cause the bulb to burn out.
Oven light does not turn off. Check for obstruction in oven door. Check to see if hinge is bent.
Cannot remove lens cover on light. There may be soil build-up around the lens cover. Wipe lens cover area
with a clean dry towel prior to attempting to remove the lens cover.
Oven is not self-cleaning properly. Allow the oven to cool before running self-clean. Always wipe out loose
soils or heavy spillovers before running self-clean. If oven is badly soiled,
set oven for the maximum self-clean time.
Clock and timer are not working properly. Make sure there is electrical power to oven.
"E" and a number appears in display and
control beeps.
This is a fault code. Press any key or turn knob to stop beeping. Reset
oven if necessary. If fault code remains, record fault code, cancel oven and
call authorized service technician.
With a new oven there is a strong odor
when oven is turned on.
This is normal with a new oven and will disappear after a few uses.
Operating the self-clean cycle also "burns-off" the smell more quickly.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch hbn 3550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch hbn 3550 in the language / languages: English as an attachment in your email.

The manual is 3,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info