644851
11
Zoom out
Zoom in
Previous page
1/28
Next page
11
Before using the self-clean function
The oven must be empty. Remove accessories, pans, guides or
left and right hand side rails. See the Cleaning and Care
chapter to release the guides or left and right hand side rails.
Clean the oven door and the side surfaces inside the oven
around the area with seals.
: Risk of fire!!
The remains of food and grease as well as roasting juices can
catch fire. Use a damp cloth to clean the inside of the oven and
the accessories that will be cleaned inside the oven.
Cleaning of the accessories
The wire shelves or left and right hand side rails are not
suitable for self cleaning. Remove these from the oven.
For optimum cleaning of the oven interior, it is recommended
that the self-clean function is not used with the trays. However,
with the accessory support, the universal deep enamel tray or
the flat enamel oven tray can also be cleaned using the self-
clean function. Only clean one accessory at a time.
The shelf should not be cleaned using the self-clean function.
If your oven does not have this support, it can be purchased
from the Technical Assistance Service or over the Internet by
quoting part number 466546.
The accessory support is inserted to the right and left.
Use water to clean food remains, oil and roasting juices from
the accessories.
Place the universal deep tray or the flat oven tray on the
support.
: Significant health risks!
Do not place non-stick baking tins or trays in the oven during
self-cleaning. The intense heat removes the non-stick surface
and creates toxic gases.
Setting
Once the cleaning level has been selected, set the oven.
1. Select the Self-cleaning q function with the function control
knob.
2. Set the required cleaning level using the @ or A sensors.
The display panel will show the cleaning level and the
x symbol. Self-cleaning starts within a few seconds.
The oven door locks shortly after the function has started. The
H symbol lights up on the display panel. Only when the
H symbol turns off can the oven door be opened again.
Self-cleaning has ended.
The display panel will show
‹‹:‹‹. The oven will stop heating.
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H symbol on the display panel turns off.
Changing the cleaning level
The cleaning level cannot be changed once it has started.
Stopping the self-cleaning
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H symbol on the display panel turns off.
Delaying the end time
The oven allows you to programme the self-cleaning end time.
Self-cleaning can therefore be programmed at night for
example, leaving the oven free for use during the day.
Programme as described in section 1 and 2. Before starting the
self-cleaning, press the
0 sensor three times and delay the
end time with the
@ or A sensors.
The oven is set to standby. The display panel will show the
cleaning level and the
y symbol. When self-cleaning starts, the
cleaning level and the
x symbol are shown. The y symbol
switches off.
Viewing the time settings
To view the duration of the cleaning level or the end time of the
self-cleaning press the
0 sensor repeatedly until the required
symbol lights up. The corresponding value will be shown for a
few seconds on the display panel.
After using the self-clean function
Once the inside of the oven has cooled, clean the ash remains
using a damp cloth.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch HBA64B261 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch HBA64B261 in the language / languages: English as an attachment in your email.

The manual is 1,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch HBA64B261

Bosch HBA64B261 User Manual - German - 28 pages

Bosch HBA64B261 User Manual - Dutch - 28 pages

Bosch HBA64B261 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info