786291
20
Zoom out
Zoom in
Previous page
1/317
Next page
20 | English
Line Laser GLL 3‑80 C GLL 3-80 CG
Permitted ambient temperature during
operation –10°Cto+40°C –10°Cto+40°C
Permitted ambient temperature during
storage –20°Cto+70°C –20°Cto+70°C
Recommended rechargeable batteries GBA 12V…
(except for GBA12V≥4.0Ah) GBA 12V…
(except for GBA12V≥4.0Ah)
Recommended chargers GAL 12…
GAX 18… GAL 12…
GAX 18…
A) The working range may be reduced by unfavourable environmental conditions (e.g. direct sunlight).
B) At 20–25°C
C) Applies to the four horizontal intersection points
D) The values stated presuppose normal to favourable environmental conditions (e.g. no vibration, no fog, no smoke, no direct sunlight). Ex-
treme fluctuations in temperature can cause deviations in accuracy.
E) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by condensation is expected.
F) Shorter operating times in Bluetooth® operation and/or in conjunction with RM3
G) When using Bluetooth® Low Energy devices, it may not be possible to establish a connection depending on the model and operating system.
Bluetooth® devices must support the SPP profile.
H) The signal range may vary greatly depending on external conditions, including the receiving device used. The Bluetooth® range may be signi-
ficantly weaker inside closed rooms and through metallic barriers (e.g. walls, shelving units, cases, etc.).
I) The lithium-ion battery and the AA1 battery adapter are excluded from IP54.
The serial number (18) on the type plate is used to clearly identify your measuring tool.
Assembly
Measuring Tool Power Supply
The measuring tool can be operated either with conventional
non-rechargeable batteries or with a Bosch lithium-ion bat-
tery.
Operation with Rechargeable Battery
uUse only the chargers listed in the technical data. Only
these chargers are matched to the lithium-ion battery of
your measuring tool.
Note: Lithium-ion rechargeable batteries are supplied par-
tially charged according to international transport regula-
tions. To ensure full rechargeable battery capacity, fully
charge the rechargeable battery before using your tool for
the first time.
To insert the charged battery (15), slide it into the battery
bay (10) until you feel it engage.
To remove the battery (15), press the release buttons (13)
and pull it out of the battery bay (10). Do not use force to
do this.
Operation with Non-Rechargeable Batteries
It is recommended that you use alkaline manganese batter-
ies to operate the measuring tool.
The batteries are inserted into the battery adapter.
uThe battery adapter is intended only for use in desig-
nated Bosch measuring tools and must not be used
with power tools.
To insert the batteries, slide the cover (11) of the battery
adapter into the battery bay (10). Place the batteries into
the cover as per the illustration on the sealing cap (14).
Slide the sealing cap over the cover until you feel it click into
place.
To remove the batteries (12), press the re-
lease buttons (13) of the sealing cap (14) and
pull off the sealing cap. Make sure that the bat-
teries do not fall out. To do this, hold the meas-
uring tool with the battery bay (10) facing up-
ward. Remove the batteries. To remove the
cover (11) from inside the battery bay, reach
into the cover and pull it out of the measuring
tool, applying light pressure to the side wall as you do so.
Always replace all the batteries at the same time. Only use
batteries from the same manufacturer and which have the
same capacity.
uTake the batteries out of the measuring tool when you
are not using it for a prolonged period of time. The bat-
teries can corrode and self-discharge during prolonged
storage in the measuring tool.
Battery Charge Indicator
The battery charge indicator(2) shows the state of charge of
the battery/batteries:
LED State of charge
Green continuous light 100–75%
Yellow continuous light 75–35%
Red continuous light 35–10%
No light Rechargeable battery de-
fective
Batteries drained
If the rechargeable battery or non-rechargeable batteries are
running low, the laser lines will gradually become dimmer.
1 609 92A 7GY | (21.04.2022) Bosch Power Tools
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch GLL 3-80 C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch GLL 3-80 C in the language / languages: All languages as an attachment in your email.

The manual is 10.81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info