733409
17
Zoom out
Zoom in
Previous page
1/283
Next page
English | 17
Bosch Power Tools 1 609 92A 3EV | (16.5.17)
Water Tanks with outlet connections
(see figure I)
When connecting the pressure washer to a water tank with a
suitable tap outlet, first connect the supply hose (not provid-
ed) to the tank outlet, open the tap to allow the water to dis-
place all the air in the hose and then connect to the pressure
washer.
Use of detergents (see figure J)
Only use detergents recommended by the manufacturer.
Comply with the application, disposal and warning instruc-
tions of the detergent manufacturers.
Pull out the suction hose at the rear and put it into a bottle
withdetergent (not supplied with).
Pull the nozzle of the lance into low pressure position.
Switch on the gun. After a few seconds foam exits at the nozzle.
Ajust the knob at the rear to dose the quantity.
Turn the nozzle left/right to adjust the water jet.
Troubleshooting
Problem Possible Cause Corrective Action
Motor refuses to start Plug not connected Connect plug
Mains socket faulty Use another socket
Fuse faulty/blown Replace fuse
Extension cable damaged Try without extension cable
Motor protector has activated Allow to cool for 15 minutes
Frozen Wait for pump/water supply hose/acces-
sory to thaw
Motor stops Fuse faulty/blown Replace fuse
Wrong mains voltage Check that mains voltage corresponds to
specifications on the model tag
Motor protector has activated Allow to cool for 15 minutes
Fuses blow Fuses incorrectly rated Change to a mains supply higher than the
pressure washer amp consumption
Motor starts but no pressure Nozzle partly blocked Clean nozzle
Motor “sounds” but fails to start Insufficient power supply Check that the voltage of the mains pow-
er supply line is the same as that on the
plate
Voltage loss due to use of extension cable Check characteristics of extension cable
Appliance not used for a long period of
time Contact your Bosch Service Centre
Problems with TSS (Total Stop System)
device Contact your Bosch Service Centre
Pressure pulsating Air in the inlet water supply hose/pump Allow pressure washer to run with open
spray handle and nozzle at low pressure
until regular working pressure is obtained
Inadequate water supply Check that the water supply corresponds
to specifications. The minimum specifica-
tion for the water supply hose is 1/2" or
13 mm diameter
Water filter blocked Clean water filter
Water supply hoses squeezed Straighten out kinked water supply hoses
High pressure hose too long Remove high pressure extension hose.
Retry (extension hose max. 7m)
Pressure too low, but steady
Note: Several types of accessory will nor-
mally deliver a lower pressure
Nozzle worn Change the nozzle
Start/stop valve worn Activate trigger five times in quick suc-
cession
OBJ_BUCH-2319-004.book Page 17 Tuesday, May 16, 2017 11:15 AM
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch GHP 5-65 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch GHP 5-65 in the language / languages: All languages as an attachment in your email.

The manual is 20,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info