786210
11
Zoom out
Zoom in
Previous page
1/126
Next page
English | 11
Status LED Rechargeable
battery capacity,
approx.
The first LED is continuously lit. ≥20%
The first two LEDs are continuously
lit. ≥40%
The first three LEDs are continuously
lit. ≥60%
The first four LEDs are continuously
lit. ≥80%
All five LEDs are continuously lit. >95%
Note: The charging process is only possible when the tem-
perature of the battery is within the permitted charging tem-
perature range, see section "Technical data".
When the charging bay(2) is in standby mode, the first LED
of the corresponding battery charge indicator(4) is continu-
ously lit green.
Red temperature monitoring/error indicator (5)
Continuous light
The continuous red light indicates that the
temperature of the battery is outside the per-
mitted charging temperature range, see "Tech-
nical Data" section. The charging process be-
gins as soon as the permitted temperature range has been
reached.
Flashing light
The flashing red light indicates that the battery
in this charging bay is faulty.
If six red lights flash simultaneously, this indic-
ates that the battery charger is faulty.
Errors – causes and corrective measures
Cause Corrective measures
Red temperature monitoring/error indicator(5) is flash-
ing (at the individual charging bay)
Charging not possible
The rechargeable battery is
not connected (correctly) Connect rechargeable bat-
tery to charger correctly
The battery contacts and
charging contacts are dirty Clean the battery and char-
ging contacts; e.g. by con-
necting and disconnecting
the rechargeable battery sev-
eral times. Replace the re-
chargeable battery if neces-
sary
Rechargeable battery defect-
ive Replace the rechargeable
battery
Six red temperature monitoring/error indicators(5) are
flashing simultaneously
The charger has identified an
internal error Ensure that all rechargeable
batteries are fully inserted.
Pull out the mains plug and
then plug it back in again. If
Cause Corrective measures
the error occurs again, have
charger checked if necessary
by an authorised after-sales
service centre forBosch
power tools
Indicators do not light up
Mains plug of the battery
charger is not (correctly)
plugged in
Insert the mains plug (fully)
into the plug socket
Plug socket, mains cable or
battery charger defective Check the mains voltage,
have the battery charger
checked if necessary by an
authorised after-sales ser-
vice centre for Bosch power
tools
Practical advice
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
When the charger is used continuously, or for several con-
secutive charge cycles without interruption, the charger may
heat up. This is, however, harmless and does not indicate
that the charger has a technical defect.
Installation on an L-Boxx
uPull the plug out of the socket before carrying out any
work on the charger.
For ease of transportation, the battery charger can be fitted
to an L-BOXX by means of an L-BOXX adapter(7) (one-
sided). To do this, fit the accompanying L-BOXX adapter(7)
with the accompanying four screws(8) to the bottom of the
charger (see figure below).
(7)
(8)
Hook the L-BOXX adapter(7) into the L-BOXX (see figureB).
Bosch Power Tools 1 609 92A 5KP | (17.08.2020)
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch GAL 18V6-80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch GAL 18V6-80 in the language / languages: All languages as an attachment in your email.

The manual is 2.16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info