458018
73
Zoom out
Zoom in
Previous page
1/88
Next page
6 720 645 347 (2010/09)
Energy saving tips | 73
10 Energy saving tips
The temperature in the lead room (where the
controller is fitted) acts as a guide for the
heating circuit to which the controller is
assigned. Therefore, set the output of the
radiators inside the lead room as low as
possible:
For manual valves via preselection.
With fully opened thermostatic valves via
the return fitting.
If the thermostatic valves in the lead room
are not fully open, they may reduce the
heat supply even though the controller
requests heat.
Regulate the temperature in adjacent rooms
via thermostatic valves.
External heat in the lead room (e.g. solar
radiation, stove etc.) can result in too little
heating in adjacent rooms (the heating system
remains cold).
Make effective use of the temperature levels
and switching times by setting them to suit
the preferences of the occupants.
Comfort = For a comfortable living
environment
Economy = For an active living
environment
Frost = For when away or asleep
Much energy can be saved by reducing the
room temperature via economy phases.
Reducing the room temperature by 1 K ( °C)
enables up to 5% energy to be saved.
It is not recommended to let the room
temperature of heated rooms fall below
+15 °C during the daytime, otherwise the
cooled-down walls continue to radiate cold
and the room temperature rises higher,
leading to higher energy consumption than if
an even heat supply is applied.
Good thermal insulation of the building: the
set temperature for Economy is never
reached. Nevertheless energy is being saved
as the heating system stays off.In that case set
the switching point for Economy to an earlier
time.
Don't keep windows slightly open for
ventilation. This leads to a constant extraction
of heat from the room without noticeably
improving the ambient air in the room.
Vent briefly but intensively (open window
fully).
When ventilating, turn off the thermostatic
valve or set the operating mode selector to
Frost.
Make effective use of the temperature levels
and switching times for the domestic hot
water by setting them to suit the preferences
of the occupants.
If heat-up optimisation is switched on:
To make best use of heat-up optimisation, set
the times for heating up to the temperature
levels for Economy or Comfort as late as
possible.
The heat-up optimisation function learns the
conditions in the lead room Æ chapter 8.3 on
page 59.
The first time heat-up optimisation is used,
there may be significant temperature
differences. During the initial learning phase,
do not change the setting before heat-up is
complete. After a few days, the learning
process will have advanced and the control
accuracy will improve.
Set the temperature for Economy or Frost
as
low as possible.
During Economy or Frost the lead room
conditions must remain constantly the same
Æ chapter 8.3 on page 59.
If the conditions change, it can take several
days for heat-up optimisation to adapt to the
new conditions.
73


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch FR 110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch FR 110 in the language / languages: English as an attachment in your email.

The manual is 4,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch FR 110

Bosch FR 110 User Manual - German - 40 pages

Bosch FR 110 User Manual - Dutch - 88 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info