708231

Bosch EasyShear Manual

15
Zoom out
Zoom in
Previous page
1/236
Next page
English | 15
During the charging procedure, the handle of the machine
warms up. This is normal.
The charger level indicator (1) continuously lights up red
during the charging procedure. When the battery is com-
pletely charged, the charger level indicator (1) goes out.
Disconnect the battery charger from the mains supply when
charging process ends.
Observe the notes for disposal.
Mounting/Removing the Blade (see figures C)
Press the release button (12) and slide the cover (5) toward
the rear. Remove the cover (5) from the housing.
Tilt the blade (6)/(7) upward and then remove the blade
(6)/(7).
Align the recesses on the blade (6)/(7) against the holding
pins and then tilt the blade (6)/(7) downward.
Mount the cover (5) again and then slide it toward the front
until it engages.
Operation
u Make sure that the cover of the USB port (2) is shut dur-
ing operation. This prevents the penetration of dust.
u Do not use a damaged blade (e.g. cracks, etc.). Replace a
damaged blade immediately.
Switching On and Off (see figure D)
Press and hold the lock-off button (4) and actuate the On/
Off switch (3).
Release the lock-off button (4).
When actuating the On/Off switch (3), the LED continuously
lights up green.
Battery Charge Indicator
LED Capacity
LED continuously lights up green 33−100%
LED continuously lights up red
while On/Off switch is halfway
pressed.
0−33%
Cutting Shrubs (only Shrub Shear)
u Make sure that the product is switched off when removing
cut-off material or during maintenance. Unintentional
switching on may cause serious injury.
Before cutting check the hedge/shrub for foreign objects
e.g. wire fences.
Cut stems up to 8 mm in thickness. When cutting, move the
product steadily along the line of cut, so that stems are fed
directly into the cutter blades. The double edge of the cut-
ting blade enables cutting to either direction, or with a side
to side motion.
After use, mount the blade guard.
Recommended times
Cut hedges with deciduous leaves in June and October.
Cut evergreen hedges in April and August.
Cut conifer and other fast growing shrubs approx. every six
weeks from May onwards.
Cutting Edges (only Grass Shear)
Guide the product along the edge of the lawn. Prevent the
blade from coming into contact with paved paths, stones or
garden walls because this significantly reduces the lifetime
of the blade.
After use, mount the blade guard.
Troubleshooting
Problem Possible Cause Corrective Measure
Cutting time per bat-
tery charge too low
Battery close to end of service life. Contact Service Agent.
Charger level indicator
lights up red and the
product cannot be
switched on.
Battery temperature too high Ambient temperature too high Do not expose the
product to direct sunlight. Wait 10–15 minutes to
let battery cool down.
Maintenance and Service
Maintenance, Cleaning and Storage
u To ensure safe and efficient operation, always keep
the power tool and the ventilation slots clean.
u For safe and proper working, always keep the product
clean.
Do not place other objects on the garden product.
To ensure safe and efficient operation, always keep the
product and the ventilation slots clean.
Never spray the product with water.
Never immerse the product in water.
Store the product in a secure, dry place, out of the reach of
children.
Do not place other objects on the product.
Keep all nuts, bolts and screws tight to ensure safe working
with the product.
Inspect the product and replace worn or damaged parts for
safety.
Ensure replacement parts fitted are Bosch-approved.
Bosch Power Tools F 016 L81 893 | (09.12.2019)
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch EasyShear at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch EasyShear in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info