657566
26
Zoom out
Zoom in
Previous page
1/141
Next page
English5
0 276 001 YYY | (12.10.12) Bosch eBike Systems
Power Supply of External Devices via USB
Connection
With the USB connection, it is possible to operate and charge
most devices whose power supply is possible via USB (e.g.,
various mobile phones).
Prerequisite for the charging is that the drive HMI and a suffi-
ciently charged battery pack are inserted in the eBike.
Open the protective cap 8 of the USB port on the drive HMI.
Using a matching USB cable, connect the USB port of the ex-
ternal dev
ice to the USB port 7 of the drive HMI.
Notes on Riding with the eBike System
When does the eBike Drive Operate?
The eBike drive supports you when riding, as long as you step
into the pedals. Without pedaling, there is no assistance. The
motor output always depends on the amount of your pedaling
power.
When applying less pedaling power, the assistance or support
will be lower than when applying a lot of pedaling power. This
applies indepe
ndent of the assistance Level.
The eBike drive automatically switches off at speeds in excess
of 25 km/h. When the speed falls below 25 km/h, the drive is
automatically available again.
An exception applies for the push-assistance function, in
which the eBike can be pushed at low speed without pedaling.
The eBike can also be ridden as a normal bicycle witho
ut as-
sistance at any time, by either switching off the eBike system
or setting the assistance level to “OFF”. The same applies
when the battery pack is empty.
Code Cause Corrective Measure
100
Internal error of the drive unit Have the drive unit checked
101
Connection problem of the drive unit Have connections and contacts checked
102
Error of the speed sensor Have the speed sensor checked
103*
Connection problem of the lighting
system
Have connections and contacts checked
104 Connection problem of the drive HMIHave connections and contacts checked
105
Temperature of the drive unit too high
(above 40 °C)
Allow the drive unit to cool down. Continued travel without assistance
from the eBike drive is possible and speeds up the cooling of the drive
unit.
200
Internal electronic error of battery
pack
Have battery pack checked
201
Temperature of the battery pack too
high (above 40 °C)
Allow the battery pack to cool down. Continued travel without eBike drive
is possible and speeds up the cooling of the battery pack.
202
Temperature of the battery pack too
low (below –10 °C)
Allow the battery pack to warm up slowly in a warm location.
203 Connection problem of battery pack Have connections and contacts checked
204
Incorrect polarity of battery pack Charge the battery pack with the original Bosch charger as described in
the operating instructions.
410
One or more buttons of the drive HMI
are blocked.
Check if any buttons are blocked, e.g. from dirt or debris. Clean the
buttons, if required.
414
Connection problem of the operating
unit
Have connections and contacts checked
418
One or more buttons of the operating
unit are blocked.
Check if any buttons are blocked, e.g. from dirt or debris. Clean the
buttons, if required.
422
Connection problem of the drive unit Have connections and contacts checked
423
Connection problem of battery pack Have connections and contacts checked
424
Communication error among the com-
ponents
Have connections and contacts checked
430
Internal battery pack of drive HMI
empty
Charge drive HMI (in holder or via USB port)
490
Internal error of the drive HMIHave the drive HMI checked
*only for eBike lighting via battery pack (country-specific)
OBJ_BUCH-1407-003.book Page 5 Friday, October 12, 2012 1:01 PM
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Drive Unit Cruise at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Drive Unit Cruise in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian as an attachment in your email.

The manual is 9,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info