35
Antes da montagem
Potência optimizada do exaustor:
❑ Tubo de exaustão curto e liso.
❑ Tubo com número mínimo de curvas.
❑ Diâmetro do tubo e curvas tão grandes
quanto possível.
A utilização de tubos de aspiração
longos e rugosos no seu interior,
muitas curvas, ou diâmetros
reduzidos, provoca uma alteração
nas condições optimizadas de
ventilação e, simultaneamente, um
aumento do nível de ruídos.
❑ Tubos circulares:
Recomendamos
um diâmetro interior de 150 mm, mas
no mínimo de 120 mm
❑ Canais planos têm que ter um secção
equivalente ao diâmetro dos tubos.
Eles não devem ter nenhum desvio
muito pronunciado.
l 120 mm ca. 113 cm
2
l 150 mm ca. 177 cm
2
❑ Se os diâmetros dos tubos
apresentarem diferenças:
Deverão ser aplicadas cintas de
vedação.
❑ No funcionamento com exaustão de
ar, deve ser garantida uma renovação
de ar suficiente.
Ligação do tubo de exaustão
l 150 mm:
❑ Fixar o tubo de exaustão directamente
no bocal.
Ligação do tubo de exaustão
l 120 mm:
❑ Encaixar o bocal de redução no bocal
de saída de ar – Fig. 3– e, depois, fixar
o tubo de exaustão de ar.
Função de circulação de ar Fig. 4
❑ Com filtro de carvão activo, se não
existirem condições para funcionamento
de exaustão.
ṇSe o exaustor for adequado para a
função de circulação de ar, poderá adquirir
o conjunto de montagem completo no
comércio especializado.
Preparação do tecto
❑
O tecto tem que estar plano e
horizontal.
❑
Tem que ser prevista uma fixação
segura das buchas. As buchas anexas
são indicadas para betão e pedras
naturais.
No caso dos materiais do tecto serem
diferentes, têm que ser aplicados meios
de fixação indicados para isso.