Manual Bosch DHI 945 F (page 28 of 96) (English, German, Dutch, French, Italian, Portuguese, Spanish, Spanish)

108628

Zoom out

Zoom in

1/96

1. Disconnect from power.

2. Disconnect pipes.

3. Remove ﬁlters.

4. Undo right and left ﬁxing screws until the

extractor hood cannot drop any further.

5. Raise the extractor hood brieﬂy until the

ﬁxing lugs detach and the appliance can

be lowered.

ṇ Fastening screws may project.

When raising the extractor hood, do not

force in the ﬁlter drawer.

6. Preparing for re-installation:

Screw in the left and right ﬁxing screws

until the lugs are pressed out at the

sides.

Electrical connection

WARNING: THIS APPLIANCE MUST BE

EARTHED

IMPORTANT: Fitting a Different Plug:

The wires in the power cord are colour-

coded as follows:

Green and Yellow – Earth

Blue – Neutral

Brown – Live

If you ﬁt your own plug, the colours of

these wires may not correspond with the

identifying marks on the plug terminals.

Proceed as follows:

1. Connect the green and yellow (Earth)

wire to the terminal in the plug marked

‘E’ or with the symbol ( ), or

coloured green or green and yellow.

2. Connect the blue (Neutral) wire to the

terminal in the plug marked ‘N’ or

coloured black.

3. Connect the brown (Live) wire to the

terminal marked ‘L’, or coloured red.

The extractor hood may be connected to

a correctly installed earthed socket only.

Attach the earthed socket near the

extractor hood in an accessible position.

❑

The earthed socket should be

connected via its own power circuit.

ṇ If appliances do not feature the OFF

delay function, the indicator may start ﬂas-

hing when the extractor hood has been

switched off for several hours via a separa-

te switch, even though the grease ﬁlters are

not yet saturated.

(See instructions for use, section on ﬁlter

and maintenance).

Electrical speciﬁcations:

These can be found on the rating plate

inside the appliance following removal of

the ﬁlter frames.

ṇ Before carrying out repairs, always

isolate the appliance.

Length of the connection cable: 1.30 m.

If permanent connection is required:

The extractor hood may only be connected

by an electrician registered with the local

electricity board.

A disconnecting device must be provided

on the installation side. Switches with a

contact opening of more than 3 mm and

all-pole disconnection are regarded as

disconnecting devices. These include LS

switches and contactors.

This extractor hood complies with EU

regulations on interference suppression.

Removal from the wall

cupboard

ṇ Do not lift the

extractor hood

when undoing the

ﬁxing screws.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bosch DHI 945 F in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish, Spanish as an attachment in your email.

The manual is 4,8 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bosch DHI 945 F Manual

Product: