809355

Bosch CRC R-1 Climate Room Control - wired Manual

4
Zoom out
Zoom in
Previous page
1/16
Next page
Product Information
Climate Room Control – 6721841498 (2022/04)
60
dangers. Children shall not play with the
appliance. Cleaning and user
maintenance must not be performed by
children without supervision.”
“If the power cable is damaged, it must
be replaced by the manufacturer, its
customer service department or a
similarly qualified person, so that risks
are avoided.”
2Product Information
2.1 Declaration of conformity
The design and operating characteristics of this product
comply with the European and national requirements.
The CE marking declares that the product complies
with all the applicable EU legislation, which is
stipulated by attaching this marking.
The complete text of the Declaration of Conformity is available
on the Internet: worcester-bosch.co.uk.
2.2 Scope of delivery
The appliances are shown as an example and deviations are
possible.
The scope of delivery is shown in Fig. 1.
[1] wired controller
[2] Communication cable
[3] Fixing materials
[4] Button battery
[5] Set of printed documents for product documentation
[6] Magnet ring
[7] Extension cable (6 m)
The button battery enables the time to be saved following a
power failure. If the time is not displayed correctly following a
power failure, the button battery is empty.
2.3 Technical data
Table 26
3 Installation
3.1 Prior to installation
▶ Carefully read the technical documentation of the indoor
unit, outdoor unit and other system components and
determine a suitable installation location.
▶ The ambient temperature at the installation location should
be in the following range: −5...43 °C.
▶ The relative humidity at the installation location should be
in the following range: 40. 90 %.
▶ Do not install in locations where it is likely to come into
contact with heavy fuel oil, steam or sulphur gas.
▶ Observe the dimensions of the wired room controller (
Fig. 2).
▶ Install it far from heat sources.
▶ Ensure that there is air circulation.
3.2 Mount the wired room controller
NOTICE
Damage to the wired room controller
Opening the wired room controller in the wrong way or
tightening the screws too tightly can damage it.
▶ Do no exert too much pressure on the wired room
controller.
▶ Remove the wall plinth of the wired room controller (
Fig. 5).
– Insert the tip of a screwdriver at the bending point [1]
on the rear of the wired room controller.
– Lift up the screwdriver to lever open the wall plinth [2].
▶ If necessary, prepare the wall and communication wire (
Fig. 6).
– [1] Realise putty or insulating material.
– [2] Make an elbow in the cable.
▶ Attach the wall plinth to the wall ( Fig. 7, [1]).
▶ Fix the wired room controller to the wall plinth ( Fig. 9).
CRC R-1
Input power voltage 12 V DC
Permissible ambient temperature
Tamb
−5...43 °C
Permissible relative humidity 40...90%
CRC R-1
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch CRC R-1 Climate Room Control - wired at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch CRC R-1 Climate Room Control - wired in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 4.17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info