809324
13
Zoom out
Zoom in
Previous page
1/28
Next page
Operation
13
Compress 7000 AWM/AWMS 5-17 – 6721830635 (2021/02)
Setting the summer/winter switchover threshold
CAUTION
Risk of system damage!
Do not switch over to summer mode if there is a risk of frost.
Menu: Summer/winter changeover
Table 6 Settings for the summer/winter changeover
Setting the DHW alternating operation
If DHW alternating operation is not activated, DHW heating has priority
and interrupts the heat requirement of the heating system, if necessary.
Menu: DHW alternating operation
Table 7 Settings for the DHW alternating operation
3.3.2 DHW settings
Using the extra DHW, thermal disinfection or daily heat up functions can
lead to higher electricity cost as the electric booster heater may be
activated.
If a fresh water station is installed, setting the DHW temperature ≥ 52 °C
can lead to higher electricity cost as the electric booster heater may be
activated.
Setting the operation mode for DHW heating
The installer sets the temperatures for the different modes.
Menu: Op. mode
Table 8 Settings for operation mode of DHW
Setting the time program for DHW heating
Menu: Time program
Table 9 Time program settings for DHW
Menu item Description
Heating/Cooling In summer, heating/cooling mode can be
switched off [Continuous summer].
The heating/cooling mode can be activated/shut
down based on the outside temperature (this is
only available if the [Automatic mode] is active in
the heating circuit).
The heating mode can be active [Continuous
heating]. However, heating starts only if it is too
cold inside.
The cooling mode can be active [Cooling].
However, cooling starts only if it is too hot inside.
If more than one heating circuit is installed, [Heating
circuit 1 ... 4] is displayed instead of this menu item.
Heating mode
from1)
1) This menu item is only displayed if the outdoor-temperature-dependent
switching between summer and winter modes is active for the heating circuit
concerned.
If the outside temperature2) falls below the
temperature threshold set here, the heating system
is switched on. In systems with more than one
heating circuit, this setting always relates to the
corresponding heating circuit in each case.
2) When the outside temperature is adjusted (damped), changes to the measured
outside temperature are delayed and fluctuations reduced.
Cooling mode
from
If the outside temperature exceeds the temperature
threshold set here, the heating system is switched
off and cooling is enabled. In systems with more
than one heating circuit, this setting always relates
to the corresponding heating circuit in each case.
Menu item Description
DHW alt.
operation on
In the event of simultaneous DHW and heating
demand, the system will alternate between DHW
heating and heating mode based on the times set in
[Prioritise DHW for] and [Heating priority for].
Prioritise DHW
for
Duration of DHW heating.
Heating priority
for
Duration of heating mode.
Menu item Description
Op. mode [Off]: Deactivated, no DHW production.
[Always on - DHW Eco+]1): Lowest DHW
temperature mode that results in lowest energy
consumption.
[Always on - DHW Eco]: Medium DHW
temperature mode that results in medium energy
consumption.
[Always on - DHW comfort]: Highest
temperature mode that results in higher energy
consumption.
[Own time program]: DHW time program that
operates independently of any heating circuit
time program.
1) Not available for fresh water station
Menu item Description
My DHW time
prog.
Own time program for DHW heating that works
independently of the time program for the heating
system. 6 switching times can be set for each day or
group of days. One of the operating modes can be
assigned to each switching time in automatic mode.
The minimum duration of a time slot between two
switching times is 15 minutes.
Resetting prog. The time program for the DHW system is reset to the
default setting with this menu item.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Compress 7000 AWM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Compress 7000 AWM in the language / languages: English as an attachment in your email.

The manual is 6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info