809317
16
Zoom out
Zoom in
Previous page
1/44
Next page
Installation
Compress 3400i AWS – 6721852066 (2023/01)
16
Coding switches A and P must not be adjusted! Otherwise malfunctions
and faults will occur.
Important: check the coding when a replacement part is used ( Fig.
36).
5.7.3 CAN-BUS
NOTICE
Malfunction due to faults!
Power circuit cables (230V~) cannot be near any CAN-BUS, sensor and
other signal circuit cables (12V DC).
Ensure there is a minimum distance of 100 mm between power
circuit cables and CAN-BUS, sensor and other signal circuit cables.
CAN-BUS: do not connect 12V direct voltage output "Out 12V DC" on the
installation module.
NOTICE
Mixing up the 12V and CAN-BUS connections will result in a system
fault!
The communication circuits are not designed for a constant voltage of
12V.
Make sure that both cables are connected to the correspondingly
marked connections on the printed circuit board (CAN high / CAN
low).
The outdoor unit and indoor unit are connected to each other via a
communication cable, the CAN-BUS.
A LIYCY cable (TP) 3x0.75 mm2 (or equivalent) is suitable as an
extension cable outside of the unit. Alternatively, twisted pair cables
approved for outdoor use with a minimum cross-section of 0.75 mm2
can be used. One of the shielded ends must be connected to the nearest
grounding terminal in the indoor unit structure. The other end cannot be
connected to the grounding or any metal part of the outdoor unit
structure.
The maximum permissible cable length is 30 m.
The Can Termination Switch marks the start and end of the CAN-BUS
connection. Make sure that the right boards are terminated and that all
other boards within the CAN-BUS connection are not terminated.
Fig. 12 CAN-BUS connection
[1] Indoor unit
[2] Outdoor unit
5.7.4 EMS BUS
NOTICE
Malfunction due to faults!
Power circuit cables (230V~) cannot be near any EMS-BUS, sensor and
other signal circuit cables (12V DC).
Ensure there is a minimum distance of 100 mm between power
circuit cables and EMS-BUS, sensors and other signal circuit cables.
The control unit is connected via the EMS-BUS to the installer module of
the indoor unit.
The control unit is supplied with power via the BUS cable. The polarity of
the two EMS-BUS cables is irrelevant.
The following applies to accessories that are connected to the EMS-BUS
(see also the installation instructions for the respective accessories):
If several BUS units are installed, there must be a minimum spacing of
100 mm between them.
If several BUS units are installed, connect them in parallel or in a star
configuration.
Use cable with a minimum cross-section of 0.5 mm2.
In case of external inductive interferences (e.g. from PV systems),
use screened cables. Connect only one end of the cable shield to the
nearest ground.
2
1
0010036947-001
LN
Can H
Can L
GND
Out 12V DC
CAN high
CAN low
gnd
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Compress 3400i AWS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Compress 3400i AWS in the language / languages: English as an attachment in your email.

The manual is 7.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch Compress 3400i AWS

Bosch Compress 3400i AWS User Manual - English - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info