746691
15
Zoom out
Zoom in
Previous page
1/24
Next page
en Cleaning
14
DCleaning
Cl eani ng
With good care and cleaning, your appliance will retain
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.
:Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
:Warning – Risk of serious harm to health!
The surface of the appliance may become damaged if it
is not cleaned properly. Microwave energy may escape.
Clean the appliance on a regular basis, and remove any
food remnants immediately.~ "Cleaning agent"
on page 14
:Warning – Risk of electric shock!
Do not immerse the appliance in water or clean under a
jet of water.
Note: Unpleasant odours, for example after fish has
been prepared, can be removed very easily. Add a few
drops of lemon juice to a cup of water. Always place a
spoon in the container to prevent delayed boiling. Heat
the water for 1 to 2 minutes at maximum microwave
output.
Cleaning agent
To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table.
Do not use:
Harsh or abrasive cleaning agents.
Metal or glass scrapers to clean the door panels.
Metal or glass scrapers to clean the door seal.
Hard scouring pads or sponges.
Cleaning agents with a high alcohol content.
Wash new sponge cloths thoroughly before use.
Area Cleaning product
Appliance front Hot soapy water: Clean using a dish cloth and
then dry with a soft cloth. Do not use metal or
glass scrapers for cleaning.
Appliance front with
stainless steel
Hot soapy water: Clean using a dish cloth and
then dry with a soft cloth. Remove splashes
and patches of limescale, grease, starch and
albumin (e.g. egg white) immediately. Corro-
sion can form under these patches or
splashes. Special stainless-steel cleaning prod-
ucts are available from the after-sales service
or from specialist retailers. Do not use glass
cleaners or metal or glass scrapers for clean-
ing.
Cooking compart-
ment made of stain-
less steel
Hot soapy water or vinegar solution: Clean
using a dish cloth and then dry with a soft
cloth.Do not use oven spray or any other
aggressive oven cleaners or abrasive materi-
als. Scouring pads, rough sponges and pan
cleaners are also unsuitable. These items
scratch the surface. Allow the interior surfaces
to dry completely.
Recess in the cook-
ing compartment
Damp cloth: Water must not be allowed to run
into the appliance through the turntable drive.
Dry the turntable drive with a cloth.
Turntable and roller
ring
Hot soapy water: When placing the turntable
back into its recess, it must engage properly.
Door panels Glass cleaner: Clean with a dish cloth. Do not
use glass scrapers.
Area Cleaning product
Trouble shooting en
15
3Trouble shooting
Tr oubl e shoot i ng
If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Tip: If a dish does not turn out exactly as you wanted,
refer to the following chapter, where you will find lots of
tips and notes relating to the optimum
settings.~ "Tested for you in our cooking studio"
on page 17
:Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault table
--------
Fault Possible cause Remedy/information
The appliance is not working The plug is not plugged into the mains Connect the appliance to the electricity supply
Power failure Check whether other kitchen appliances are working
The circuit breaker/fuse is faulty Check in the fuse box to make sure that the circuit
breaker/fuse for the appliance is in working order
Faulty operation Switch off the circuit breaker/fuse for the appliance in
the fuse box and switch it back on after approximately
10 seconds
Three zeros are lit on the display. Power failure Reset the time.
The appliance is not operating. A
cooking time is shown on the display.
The rotary selector has been accidentally turned. Press the "stop" button.
The "start" button has not been pressed after the set-
ting was applied.
Press the "start" button or cancel the setting by press-
ing the "stop" button.
The microwave is not working. The door has not been properly closed. Check whether food remnants or debris is/are
trapped in the door.
The "start" button has not been pressed. Press the "start" button.
It is taking longer than usual for food
to heat up
The microwave power output has been set too low. Select a higher microwave power setting.
A larger amount of food than usual has been placed in
the appliance.
Double the amount – double the time.
The food was colder than usual. Stir or turn the food during heating.
The turntable is making a scraping or
grinding noise.
Dirt or debris in the area around the turntable drive. Clean the roller ring and the recess in the cooking
compartment.
The microwave has stopped for no
apparent reason.
The microwave has a fault. If this fault recurs, please call the after-sales service.
An i is shown on the display.
The appliance is in demo mode Deactivate demo mode.
~ "Basic settings" on page 13
Error message "E - 3" Fault in automatic door opening system. If an error message is displayed, switch the appliance
off and on again; if the message disappears, it was a
one-off problem. If the fault occurs again or the error
message is still displayed, please contact the after-
sales service and provide the fault code.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch BFL553MW0B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch BFL553MW0B in the language / languages: English as an attachment in your email.

The manual is 1,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info