746678
19
Zoom out
Zoom in
Previous page
1/28
Next page
en Cleaning
18
Changing the time
If you want to change the time, for example from
summer to winter time, you have to change the basic
setting.
The appliance must be switched off.
1. Touch the ° field for approx. 3 seconds.
Notes on the process appear on the display.
2. Press the s field to confirm the notes.
The first setting "language" appears in the display.
3. Touch the s field.
The setting for the clock appears.
4. Turn the rotary selector to change the clock time.
5. Press and hold the ° field for approx. 3 seconds to
confirm the setting.
A note is shown on the display to confirm that the
settings have been saved.
DCleaning
Cleaning
With good care and cleaning, your appliance will retain
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.
:Warning
Risk of burns!
The appliance becomes very hot. Never touch the
interior surfaces of the cooking compartment or the
heating elements. Always allow the appliance to cool
down. Keep children at a safe distance.
:Warning
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:Warning
Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Note: Unpleasant odours, for example after fish has
been prepared, can be removed very easily. Add a few
drops of lemon juice to a cup of water. Always place a
spoon in the container to prevent delayed boiling. Heat
the water for 1 to 2 minutes at maximum microwave
output.
Cleaning agent
To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table.
Do not use:
Harsh or abrasive cleaning agents.
Metal or glass scrapers to clean the door panels.
Metal or glass scrapers to clean the door seal.
Hard scouring pads or sponges.
Cleaning agents with a high alcohol content.
Wash new sponge cloths thoroughly before use.
Area Cleaning agent
Appliance front Hot soapy water: Clean using a dish cloth and
then dry with a soft cloth. Do not use a metal or
glass scraper for cleaning.
Display Wipe down using a microfibre cloth or a
slightly damp cloth. Do not wipe with a wet
cloth.
Stainless steel Hot soapy water: Clean using a dish cloth and
then dry with a soft cloth. Remove flecks of
limescale, grease, starch and albumin (e.g.
egg white) immediately. Corrosion can form
under such flecks. Special stainless-steel
cleaning agents are available from the after-
sales service or from specialist retailers.
Cooking compart-
ment made of stain-
less steel
Hot soapy water or vinegar solution: Clean
using a dish cloth and then dry with a soft
cloth. Do not use oven spray or any other
aggressive oven cleaners or abrasive materi-
als. Scouring pads, rough sponges and pan
cleaners are also unsuitable. These items
scratch the surface. Allow the interior surfaces
to dry thoroughly.
Door panels Glass cleaner: Clean with a dish cloth. Do not
use a glass scraper.
Door seal
Do not remove.
Hot soapy water: Clean with a dish cloth and
do not scour. Do not use a metal or glass
scraper for cleaning.
Accessories Hot soapy water: Soak and clean with a dish
cloth or brush.
Trouble shooting en
19
3Trouble shooting
Trouble shooting
If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Tip: If a dish does not turn out exactly as you wanted,
refer to the following chapter, where you will find lots of
tips and notes relating to the optimum
settings.~ "Tested for you in our cooking studio"
on page 21
:Warning
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault table
--------
Fault Possible cause Remedy/information
The appliance does not work or the
display is not working
The plug is not plugged into the mains Connect the appliance to the electricity supply
Power cut Check whether other kitchen appliances are working
The circuit breaker is faulty Check in the fuse box to make sure that the fuse for
the appliance is OK
Faulty operation Switch off the circuit-breaker for the appliance in the
fuse box and switch it back on after approx. 60 sec-
onds
The appliance cannot be started The appliance door is not fully closed Close the appliance door
Appliance does not heat up.
Them symbol for demo mode is
shown in the display.
The appliance is in demo mode Deactivate demo mode in the basic settings.
To do this, briefly disconnect the appliance from the
mains (switch off the household fuse or the circuit
breaker in the fuse box). Then deactivate demo mode
in the basic settings within 3 minutes.
The rotary selector has fallen out of
the support in the control panel.
The rotary selector has been accidentally disengaged. The rotary selector can be removed. Simply place the
rotary selector back in its support in the control panel
and push it in so that it engages and can be turned as
usual.
The rotary selector can no longer be
turned easily.
There is dirt under the rotary selector. The rotary selector can be removed. To disengage the
rotary selector, simply remove it from the support.
Alternatively, press on the outer edge of the rotary
selector so that it tips and can be picked up easily.
Carefully clean the rotary selector and its support on
the appliance using a cloth and soapy water. Dry with
a soft cloth. Do not use any sharp or abrasive materi-
als. Do not soak or clean in the dishwasher.
Do not remove the rotary selector too often so that the
support remains stable.
The interior lighting is not working The interior lighting is faulty Call the after-sales service
Error message "Exxx"* If an error message is displayed, switch the appliance
off and on again; if the message disappears, it was a
one-off problem. If the fault occurs again or the error
message is still displayed, please contact the after-
sales service and provide the fault code.
* Special features:
Error message "E0532": Open and close the appliance door.
Error message "E6501": Switch off the appliance. Wait for 10 minutes. Switch the appliance on again.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch BER634GS1B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch BER634GS1B in the language / languages: English as an attachment in your email.

The manual is 2,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info