591613

Bosch AXT 25 D Manual

20
Zoom out
Zoom in
Previous page
1/258
Next page
20 | English
F 016 L81 145 | (28.8.14) Bosch Power Tools
Longer material standing out from the machine could
lash out when being pulled in by the knives! Please
keep at safe distance!
– Only insert as much material so that the chute assembly 8
will not be blocked up.
– Shred withered, moist material and garden waste which
has been stored for some days alternately with branches.
This prevents the cutting roller 16 from clogging.
– Do not fill soft waste such as kitchen rubbish into the
shredder but compost directly.
– Take care that the shredded material can fall freely from
the discharge chute – danger of backing up!
– The ventilation slots 3 must not be covered by the shred-
ded material.
– Avoid blocking the discharge chute with shredded material
as this could result in kickback of material through the
chute assembly 8 opening.
Advice on Shredding
Branches become harder to shred depending on the type, age
and dryness of the wood.
For best results, shred fresh branches soon after they have
been cut.
Soft garden waste should be shredded in smaller loads, par-
ticularly when wet. Any blockages can be avoided by intermit-
tently shredding branches.
Pressure Plate Adjustment (see figureH)
The pressure plate 15 is factory adjusted and may not require
adjustment before the first use.
Adjustment of the pressure plate 15 is necessary as a result of
wear (shredded material, e. g. branches, hangs together as a
chain and is not properly cut through).
With the motor running in the forward direction (green button
4), turn the adjustment knob 10 a small amount at a time in a
clock wise direction until a light grinding sound can be heard
(the cutting roller 16 cuts the pressure plate 15 to the proper
clearance, and some small aluminium shavings fall out of the
ejection chute).
To check, look for shavings in the collection box 11.
Readjust only to the required extent, otherwise the pressure
plate 15 could wear unnecessarily.
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your garden product does not operate
properly. If these do not identify and correct the problem, contact your service agent.
Warning! Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled.
Problem Possible Cause Corrective Action
Machine fails to operate Collection box not fitted correctly Fit collection box correctly
Chute assembly not fitted correctly Fit chute assembly correctly
Mains socket faulty Use another socket
Extension cable damaged Inspect cable, replace if damaged
The machine is overheated Wait until the machine cools down
Fuse faulty/blown Replace fuse
Machine beeps (also two lights
on AXT 23 TC/ 25 TC 2550 TC)
and does not start
Collection box/chute is not correctly
assembled
Ensure the collection box is in position
Ensure the chute assembly is in position and clamped
by turning the clamping knob (red) fully clockwise
Machine periodically beeps
three times and does not start.
(also two lights are flashing rap-
idly the same way on
AXT 23 TC/25 TC/2550 TC)
Undervoltage protection Press the STOP button. Wait until the machine cools
down. The machine will beep for 2 seconds and switch
to standby.
One flashing light on AXT 23 TC/
25 TC 2550 TC
None, this is ok, machine is “pluged
in” and ready to use
Machine periodically beeps
three times and does not start.
(also two lights are flashing rap-
idly the same way on
AXT 23 TC/25 TC/2550 TC)
Undervoltage protection Restart machine.
Check extension cable is as required in instructions
(lower quality extension cables can cause error)
When powered by aggregator, check its performance.
Machine beeps continuously for
10 seconds and does not start,
error cannot be cleared pressing
STOP button (also two lights are
blinking the same way on
AXT 23 TC/25 TC/2550 TC)
The electronic control unit is faulty Contact your Bosch Service Centre
OBJ_DOKU-42377-001.fm Page 20 Thursday, August 28, 2014 11:04 AM
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch AXT 25 D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch AXT 25 D in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 9,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info