632163
15
Zoom out
Zoom in
Previous page
1/224
Next page
English | 15
Bosch Power Tools F 016 L81 125 | (22.7.15)
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
22.07.2015
Mounting and Operation
Starting
For Your Safety
Warning: Switch off and remove battery from machine
before adjusting or cleaning.
The blade continues to rotate for a few seconds after
the cordless trimmer is switched off. Allow the mo-
tor/blade to stop rotating before switching “on” again.
Do not rapidly switch off and on.
Only use Bosch approved cutting elements. Cutting
performance will vary with different cutting elements.
Battery Charging
Do not use other battery chargers. The supplied battery
charger is designed for the Lithium-Ion battery in your gar-
den product.
Observe the mains voltage! The voltage of the power
supply must correspond with the data given on the name-
plate of the battery charger. Battery chargers marked with
230 V can also be operated with 220 V.
The battery is equipped with temperature monitoring that al-
lows charging only in the temperature range between 0 °C
and 45 °C. In this manner, a high battery service life is
achieved.
Note: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
The “Electronic Cell Protection (ECP)” protects the lithium-
ion battery against deep discharging. When the battery is run
down or discharged, the garden product is shut off by means
of a protective circuit: The blade no longer moves.
Do not continue to press the On/Off
switch after the garden product has
been automatically switched off. The battery can be dam-
aged.
Battery charge-control indication
The battery charge-control indicator on the handle of the
product will indicate a low charge condition of the battery by
flashing three times when the On/Off switch is pressed. If this
occurs, please remove the battery and recharge.
Charging Procedure
The charging procedure starts as soon as the mains plug is
plugged into the socket and the battery is then inserted into
the battery charger .
Due to the intelligent charging method, the charging condi-
tion of the battery is automatically detected and the battery is
charged with the optimum charging current, depending on
battery temperature and voltage.
This gives longer life to the battery and always leaves it fully
charged when kept in the charger for storage.
Note: The charging procedure is only possible when the bat-
tery temperature is within the allowable charging tempera-
ture range, see section “Technical Data”.
Flashing Battery Charge Indicator
The charging procedure is signalled by a
flashing battery charge indicator .
Continuous Lighting of the Battery Charge
Indicator
Continuous lighting of the battery
charge indicator indicates that the
battery is fully charged or that the
temperature of the battery is not with-
in the allowable charging temperature range, and cannot be
charged for this reason. The battery is charged as soon as the
allowable charging temperature range is reached.
When the battery is not inserted, continuous lighting of the
battery charge indicator indicates that the mains plug is in-
serted in the socket and that the battery charger is ready for
operation.
Henk Becker
Executive Vice President
Engineering
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Action Figure Page
Delivery Scope
1 219
Connecting the shaft
2 219
Mounting the Cutting Guard
Blade Fitting
3 220
Handle Assembly
4 221
Charging the Battery Pack
Inserting and removing the battery
pack
5 221
Check the blade
6 222
Replace the blade
7 222
Storage blade
8 222
Switching On and Off
9 223
Working Advice
10 223
Maintenance, Cleaning and Storage
11 223
Selecting Accessories
12 224
OBJ_BUCH-2510-001.book Page 15 Wednesday, July 22, 2015 9:20 AM
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch ART 23-10 - 8 LI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch ART 23-10 - 8 LI in the language / languages: All languages as an attachment in your email.

The manual is 16,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info