Manual Bosch ARM 33 (page 9 of 148) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

537926

Zoom out

Zoom in

1/148

English | 9

Bosch Power Tools F 016 L81 048 | (2.10.13)

 Only use or replace power supply cables for this unit which

correspond to the types indicated by the manufacturer.

See the operating instructions for the order no. and types.

 Never touch the mains plug with wet hands.

 Do not run over, crush or pull the power supply cable or ex-

tension lead, otherwise it may be damaged. Protect the ca-

ble from heat, oil and sharp edges.

 The extension lead must have a cross section in accord-

ance with the operating instructions and be protected

against splashed water. The connection must not be in wa-

ter.

 Always wear gardening gloves when handling or working

near the sharp blades.

Electrical Safety

 Warning! Switch off, remove plug from mains before

adjusting, cleaning or if cable is cut, damaged or entan-

gled.

 The blades continue to rotate for a few seconds after

the machine is switched off.

 Caution – do not touch the rotating blade.

Your machine is double insulated for safety and requires no

earth connection. The operating voltage is 230 V AC, 50 Hz

(for non-EU countries 220 V, 240 V as applicable). Only use

approved extension cables. Contact your Bosch Service Cen-

tre for details.

Extension cords/leads should only be used if they comply

with H05VV-F, H05RN-F types or IEC type design (60227

IEC 53, 60245 IEC 57).

If you want to use an extension cable when operating your

product, only the following cable dimensions should be used:

–1.0mm

: max. length 40 m

–1.5 mm

: max. length 60 m

–2.5 mm

: max. length 100 m

Note: If an extension cable is used it must be earthed and con-

nected through the plug to the earth cable of your supply net-

work in accordance with prescribed safety regulations.

If in doubt contact a qualified electrician or the nearest Bosch

Service Centre.

 WARNING! Inadequate extension cables can be dan-

gerous. Extension cable, plug and socket must be of

watertight construction and intended for outdoor use.

Cable connections should be kept dry and off the ground.

It is recommended for increased electrical safety to use a Re-

sidual Current Device (RCD) with a tripping current of not

more than 30 mA. Always check your RCD every time you use

it.

For products not sold in GB:

WARNING: For your safety, it is required that the plug at-

tached to the machine is connected with the extension cord.

The coupling of the extension cord must be protected against

splash water, be made of rubber or coated with rubber. The

extension cord must be used with a cable strain relief.

The connection lead must be inspected for signs of damage at

regular intervals and may only be used if in perfect condition.

If the supply cord is damaged, it must be replaced by a Bosch

Service Centre.

Products sold in GB only: Your product is fitted with an

BS 1363/A approved electric plug with internal fuse (ASTA

approved to BS 1362).

If the plug is not suitable for your socket outlets, it should be

cut off and an appropriate plug fitted in its place by an author-

ised customer service agent. The replacement plug should

have the same fuse rating as the original plug.

The severed plug must be disposed of to avoid a possible

shock hazard and should never be inserted into a mains sock-

et elsewhere.

Products sold in AUS and NZ only: Use a residual current de-

vice (RCD) with a rated residual current of 30 mA or less.

Maintenance

 Always wear gardening gloves when handling or work-

ing near the sharp blades.

 Keep all nuts, bolts and screws tight to be sure that the ma-

chine is in safe working condition.

 Check the grass catcher frequently for wear or deteriora-

tion.

 Examine the machine and replace worn or damaged parts

for safety.

 Ensure replacement cutting means of the right type are

used.

 Ensure replacement parts fitted are Bosch approved.

 Before storage ensure machine is clean and free from de-

bries, if necessary clean with a soft, dry brush.

Symbols

The following symbols are important for reading and under-

standing the operating instructions. Please take note of the

symbols and their meaning. The correct interpretation of the

symbols will help you to use the garden product in a better

and safer manner.

Symbol Meaning

Reaction direction

Movement direction

Wear protective gloves

Weight

Switching On

Switching Off

Permitted action

OBJ_BUCH-1996-001.book Page 9 Wednesday, October 2, 2013 8:30 AM

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bosch ARM 33 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 8,71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bosch ARM 33 Manual

Product: