1165
18
Zoom out
Zoom in
Previous page
1/97
Next page
English - 6
18 • F016 L70 370 • TMS • 06.09.05
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove plug from mains before investigating fault.
Fault Finding
Symptom Possible Cause Remedy
Motor refuses to start Plug not connected
Mains socket faulty
Fuse faulty/blown
Extension cable damaged
Motor protector has activated
Frozen
Connect plug
Use another socket
Replace fuse
Try without extension cable
Allow to cool for 5 minutes
Wait for pump/water supply hose/ac-
cessory to thaw
Motor stops Fuse faulty/blown
Wrong mains voltage
Motor protector has activated
Replace fuse
Check that mains voltage corresponds
to specifications on the model tag
Allow to cool for 5 minutes
Fuses blow Fuses faulty/blown Change to a mains supply higher than
the pressure washer amp consump-
tion
Excessive working pres-
sure
Nozzle partly blocked Clean nozzle
Pressure pulsating Air in the inlet water supply hose/pump
Inadequate water supply
Water strainer blocked
Water supply hoses squeezed
High pressure hose too long
Allow pressure washer to run with
open spray handle and nozzle at low
pressure until regular working pres-
sure is obtained
Check that the water supply corre-
sponds to specifications. The mini-
mum specification for the water supply
hose is 1/2" or 13 mm diameter
Clean water strainer
Straighten out kinked water supply
hoses
Dismount high pressure extension
hose. Retry (extension hose max. 7 m)
Pressure too low, but
steady
Note: Several types of ac-
cessory will normally de-
liver a lower pressure
Nozzle worn
Start/stop valve worn
Change the nozzle
Activate trigger five time in quick suc-
cession
Motor starts up but no
working pressure
No water supply
Water strainer clogged up
Nozzle clogged up
Connect water supply
Clean the water strainer
Clean nozzle
The pressure washer
starts irregularly by itself
Pump/power gun leaky Contact your Bosch Service Centre
Water leaks from ma-
chine
Leaking pump 6 drops per minute are permissible. In
case of more serious leakage, you
should contact your Bosch Service
Centre
F016 L70 370 - GB Seite 6 Donnerstag, 29. September 2005 2:57 14
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch AQUATAK 10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch AQUATAK 10 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info