555168

Bort BFP-450N Manual

5
Zoom out
Zoom in
Previous page
1/20
Next page
5
Electric spray gun
Read all instructions and product labels. When using
electrical tools, follow all precautions to reduce the risk
of fi re, electric shock, and other personal injury.
TECHNICAL SPECIFICATIONS 1
OPERATION INSTRUCTIONS 2
IMPORTANT SAFETY INSTRUCTIONS
WARNING!
When using electric appliances, basic pre-
cautions should always be followed, including the fol-
lowing:
• Read all the instructions before using the appliance.
• To reduce the risk of injury, close supervision is nec-
essary when an appliance is used near children.
• Only use attachments recommended or sold by the
manufacturer.
• To disconnect, turn all controls to the off (“O”) posi-
tion, then remove the plug from outlet.
• Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
• Unplug from outlet when not in use and before servic-
ing or cleaning.
• Do not point the paint roll or accessories toward your-
self; danger of injury by ejected material.
• The unit is not a toy; keep it away from children.
• Power cable and power plug must be undamaged.
Replace damaged parts immediately.
• Never submerge the unit in liquid!
• Do not use hot water for rinsing out and cleaning.
• The unit may not be used in workplaces bound by the
explosion-protection regulations.
• If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent or a similarly
qualifi ed person in order to avoid a hazard.
Materials to be processed:
Dilute dispersion paints and latex paints for interior and
exterior walls.
Materials not to be processed:
Paint and lacquers containing solvents and materials
containing heavily abrasive components.
INSTALLATION AND OPERATING
• Assemble the paint roll (fi gure 1).
• Mount deaeration unit, connect hoses (fi gure 2): slide
suction hose (B), paint feed hose (A) onto the respec-
tive connection pieces until they stop. Slide on screw
sleeves and tighten.
• Before beginning work, cover or tape up the fl oor, fur-
niture, door frames and other objects. Place the unit
on a suffi ciently sized piece of plastic or cardboard.
• Stir the paint well and thin up to 10% if necessary
(observe information from manufacturer).
• Submerge suction hose with suction fi lter (fi gure 3)
to the bottom of the paint container and fasten to the
paint container edge with clamp.
• Turn the control knob to the “working” position. (fi gure
4) The pressure in pipe B will reduce when it exceeds
the set value.
• Open dosage valve at handle. Switch unit on (fi gure
5). Suction and paint feed hoses and paint roll fi ll with
paint in appox.2 min. The unit is ready for operation
when the fi rst drops of paint emerge. Set the paint
feed as required using the dosage valve.
ATTENTION! Air in the suction hose or pump area can
lead to suction and function interruptions. Ensure that
the suction fi lter is always completely covered with
paint. Refi ll paint in a timely manner, set the paint con-
tainer at an angle or prepare a new paint container.
Switch off the unit before moving the suction hose to a
new paint container.
BREAKS DURING WORK
Immediately stop
Press down the button (fi gure 6), the paint roll will be
stopped fi lling with paint until the valve is opened (fi gure
7).
Short breaks (up to four hours):
• Switch off paint pump and open dosage unit in han-
dle.
• Insert paint roll into plastic bag immediately and tie it
up to airtight (fi gure 8, A).
• Leave suction and air bleed hoses in the paint.
Long breaks (days):
• Place paint roll in a bucket of water (fi gure 8, B).
• Wet the paint surface in the paint container with some
water to prevent a skin from forming.
• Used accessories which are already unscrewed are
to be placed into water immediately after use.
CLEANING
• Switch off the appliance and scrape off paint roll over
the paint container.
• Remove paint roll by snapping it from the roller frame
and clean it thoroughly separately. Detach the seal-
ing cap of the paint roll with a suitable tool. Detach
paint roll and clean all parts in lukewarm water.
• Put the suction hose A into a container which is fi lled
with clean water.
• Switch on the appliance and pump water for about 10
minutes. Shut down fi g6 and open the valve fi g 7 for
8 times during the pumping. Each closed time should
not less than 15 seconds.
• Disconnect the aluminum hose and clean it separate-
ly.
ATTENTION! When storing, always leave the dosage unit
in the handle in the open position (Figure 5).
GB
English
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bort BFP-450N at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bort BFP-450N in the language / languages: English as an attachment in your email.

The manual is 1,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info