121734

Boretti PRO 100 IX Manual

10
Zoom out
Zoom in
Previous page
1/48
Next page
8
GB
4 OPERATION
A - EXTRACTION OR RECYCLING
Your cooker hood is supplied in the extraction mode. To use the cooker hood in the recirculation mode re-programme the hood
as follows:
Starting in the recirculation mode
Press the ‘+’ button for 10 seconds (while the motor and lights are switched ‘OFF’) and the two LED lights will flash twice to
indicate confirmation that the cooker hood is in the recycling mode.
Reverting to the extraction mode
Press the ‘+’ button for 10 seconds (while the motor and lights are switched ‘OFF’) and the two LED lights will flash once to
indicate confirmation that the cooker hood is in the extraction mode.
B – BASIC INSTRUCTIONS
Lighting
Press Button 1 to switch ‘ON’ the lights.
Motor
Press LED button 2 to switch ‘ON’ the fan motor, the LED F will illuminate to confirm the motor is switched ‘ON’, and adjust
the speed of the fan motor by pressing the Button ‘+’ and ‘-‘. The fan speed will be increased if constant pressure is kept on
the (+) button.
Press LED button 5 to obtain the boost position for maximum effect and the LED C will illuminate to confirm fan is switched
‘ON’.
C – COMPLEMENTARY INSTRUCTIONS
Automatic pre-set stop for the boost speed after 10 mn.
To obtain the best performance it is advisable to switch ‘ON’ the cooker hood a few minutes (in the boost setting) before you
start cooking and you should leave it running for approximately 10 minutes after finishing.
Press LED button 5 to switch ‘OFF’ the fan motor immediately.
Indication of saturation of the metal grease filters
After 100 hours use, one quick flash of the LED F will indicate that you must clean the metal grease filters. (See chapter on
‘Maintenance’).
This indication is not available when the fan motor is switched OFF.
Indication of saturation of the active charcoal filter
After 200 hours use, two quick flash of the LEDS F & C will indicate that you must replace the active charcoal filter and clean
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Boretti PRO 100 IX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Boretti PRO 100 IX in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 5,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info