Manual Boretti CRI915 Carrara (page 23 of 272) (English, German, Dutch, French)

798851

Zoom out

Zoom in

1/272

3.6 Gas adjustments

The injectors not supplied with the appliance should be requested from the

Service Centre.

If the cooking appliance is set up for a different type of gas than that available,

its injectors must be replaced, the minimum flow regulated and the rubber-

holder changed. In order to replace the injectors in the cooking hob, it is

necessary to carry out the following operations:

* remove the pan supports;

* remove the burners and burner caps

(Fig.A);

* take out the injector (Fig. B / Fig. C) and

replace it with one suitable for the new

type of gas (see “GENERAL INJECTORS

TABLE” on page

25, 25.

);

* replace the gas label (on the rear of the

appliance) with the new one provided with

the injectors kit;

* refit all parts by following the

disassembly instructions in reverse order

and taking care to position the burner cap

correctly onthe burner.

3.6.1 Mininum ow of valved cooking hob taps

* Switch on the burner and turn the

control knob towards the minimum

flow position ;

* remove the knob;

* using a screwdriver, adjust the

internal screw Z until the correct low

flame is obtained;

* refit the knob.

* Unscrew the adjustment screw Z to increase the flow, or tighten it to

reduce the flow.

* The adjustment is correct when the low flame measures approximately 3

or 4 mm.

* For butane/propane, the adjustment screw should be tightened all the way.

* When changing quickly from maximum to minimum flow and vice versa

ENBoretti Manual CRG916 / CRI915 / User guide - Installation advice

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Boretti CRI915 Carrara in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 6.34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Boretti CRI915 Carrara Manual

Product: