533726
3
Zoom out
Zoom in
Previous page
1/132
Next page
GENERAL WARNINGS - INSTALLATION / REPAIRS -
o THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR ANY DAMAGE TO PEOPLE OR
ITEMS CAUSED BY INCORRECT INSTALLATION OR IMPROPER, WRONG OR ABSURD USE
OF THE APPLIANCE.
o Attention: earth connection is required by law.
o CONNECTION: check that the specific details on the data plate regarding the workings of
the oven correspond to your electricity supply, for the mains electricity connection it is
necessary to provide for a device which ensures disconnection from the mains electricity
supply, with a contacts opening distance which enables complete disconnection in category
III over voltage conditions, in compliance with the installation regulations.
o The oven must be connected with a cable with minimum 1.0 section in the rear, using an
omnipolar switch that complies with currently enforced laws, with an opening distance
between contacts that is equal to or more than at least 3mm.
o The manufacturer will in no way be held liable if accident prevention standards area not
observed.
o Any work on the appliance must be done with the appliance disconnected from the
electrical power supply.
o If the oven is visibly damaged or malfunctioning, do not use it. Unplug it and contact
customer services.
o It is not recommended to use adapters, multiple plugs and/or extension cords. If it is not
possible to avoid using these, always remember to use exclusively extension cords and
single or multiple adapters that comply with currently enforced laws governing safety and
that do not exceed the maximum capacity indicated on the extension cord or single
adapter, or the maximum power indicated on the multiple adapter.
o In the event of a breakdown or if indispensable repairs are required, contact customer
service.
o It is not permitted to modify, tamper with or attempt repairs on the appliance, especially
with tools (screwdrivers and the like), either inside or outside the appliance.
o Inappropriate repair work may cause serious accidents, damage the appliance and
equipment and lead to improper operation.
o Appliances repaired in technical service centres must undergo routine testing, especially
the continuity of the earth circuit.
o Make sure that the power cable of the electrical appliances is not trapped by the door. The
electrical insulation could be damaged.
o If the power cable has been damaged, it must be replaced by customer service to prevent
dangerous accidents.
GENERAL WARNINGS – FIRST USE -
o Warning: the oven must be disconnected from the electrical mains, or the electrical power
supply must be unplugged, or the system main switch must be off.
o Before using the oven, carefully clean the inside of the oven, the grills and the drip pan
using non-abrasive soap and tepid water. Insert the grill and drip pan in their respective
tracks.
o Once this has been complete, connect the oven to the mains electricity supply and switch
it onto the steam cycle (or the grill if available) for around 30 minutes, in order to
eliminate any residues of fat, oil or resin from during its manufacture which could provoke
bad odours during cooking; then, air the room.
o Once this simple operation is complete, the oven is ready for use
3
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Boretti BS45 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Boretti BS45 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 4,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info