533741

Boretti BKK75 Manual

46
Zoom out
Zoom in
Previous page
1/50
Next page
46
Installation instructions
The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
Fitting - installing:
The piece of furniture or the support in which the hob is to be tted, as well as the edges
of furniture, the laminate coatings and the glue used to x them, must be able to resist
temperatures of up to 100 °C.
• The mural rods of edge must be heat-resisting.
• The hobs are classied as “Y” class for heat protection. Ideally the hob should be installed with
plenty of space on either side. There may be a wall at the rear and tall units or a wall at one side.
On the other side, however, no unit or divider must stand higher than the hob.
• Ensure that there is a distance of 50 mm between the hob and the wall or sides.
• The cut out sizes are:
• Materials which are often used to make worktops expand on contact with water. To protect
the cut out edge, apply a coat of varnish or special sealant. Particular care must be given to
applying the adhesive joint supplied with the hob to prevent any leakage into the supporting
furniture. This gasket guaranties a correct seal when used in conjunction with smooth work top
surfaces.
• Not to install the hob to the top of a not ventilated oven or a dishwasher.
• If a drawer is placed under the work, avoid to put into this drawer ammable objects (for
example: sprays) or not heat-resistant objects.
• The safety gap between the hob and the cooker hood placed above must respect the indications
of the hood manufacturer. In case of absence of instructions respect a distance minimum of
760 mm.
• The connection cord should be subjected, after building, with no mechanical constraint, such for
example of the fact of the drawer.
• The installation of the hob in nonstationary sites (for example: boat) should be undertaken by
specialists.
Worktop Cut-out (mm) Glass size
Width x Depth Width Depth Thick
750 x 490 780 520 4
… 46 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Boretti BKK75 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Boretti BKK75 in the language / languages: English, Dutch, French, Spanish as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info