647503
75
Zoom out
Zoom in
Previous page
1/80
Next page
D
EN
35
Installation instructions
The installation comes under the exclusive res-
ponsibility of specialists.
The installer is held to respect the legislation
and the standards enforce in his home country.
How to stick the gasket:
The gasket supplied with the hob avoids all infil-
trationofliquidsinthecabinet.
His installation has to be done carefully, in con-
formity of the following drawing. Stick the gasket (2) two millimeters from the
external edge of the glass, after removing the
protection sheet (3).
2 mm
Fitting - installing:
•Thecutoutsizesare:
• Ensurethatthere is a distance of 50 mm
between the hob and the wall or sides.
• Thehobsareclassiedas“Y”classforheat
protection. Ideally the hob should be instal-
led with plenty of space on either side. There
may be a wall at the rear and tall units or a
wall at one side. On the other side, however,
no unit or divider must stand higher than the
hob.
• Thepieceoffurnitureorthesupportinwhich
the hob is to be fitted, as well as the edges
of furniture, the laminate coatings and the
glue used to fix them, must be able to resist
temperaturesofupto100°C.
• Themuralrodsofedgemustbeheat-resi-
sting.
• Nottoinstallthehobtothetopofanotven-
tilated oven or a dishwasher.
• To guaranteeunder the bottom of thehob
casing a space of 20 mm to ensure a good
air circulation of the electronic device.
• Ifadrawerisplacedunderthework,avoidto
putintothisdrawerammableobjects
(for example: sprays) or not heat-resistant
objects.
• Materials which are often used to make
worktops expand on contact with water. To
protect the cut out edge, apply a coat of
varnish or special sealant. Particular care
mustbegiventoapplyingtheadhesivejoint
supplied with the hob to prevent any leakage
into the supporting furniture. This gasket
guaranties a correct seal when used in con-
junctionwithsmoothworktopsurfaces.
• Thesafetygapbetweenthehobandthecoo-
ker hood placed above must respect the indi-
cations of the hood manufacturer. In case of
absence of instructions respect a distance
minimumof760mm.
• Theconnectioncordshouldbesubjected,af-
ter building, with no mechanical constraint,
such for example of the fact of the drawer.
Reference Cut-size
BIKP-78 750x490mm
75


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Boretti BIKP-78 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Boretti BIKP-78 in the language / languages: Dutch, French as an attachment in your email.

The manual is 2,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info