714405
25
Zoom out
Zoom in
Previous page
1/60
Next page
EN
25
Installation
www.bora.com
6 Installation
Observe all safety and warning information
(see the Safety chapter).
Follow the enclosed manufacturer‘s information
6.1 General installation information
INFO The power supply cable must be provided by the
customer.
INFO The appliance must not be installed above cooling
devices, dishwashers, stoves, ovens, washing
machines or dryers.
INFO The contact surface of the worktops and wall
sealing strips must be made of a heat-resistant
material (up to approx. 100 °C).
INFO Worktop cut-outs must be moisture-sealed using
suitable means and, where necessary, fitted with
a thermal insulator.
INFO The integrated cooktop extractor must not be
used with other cooktops.
General installation information for cooktops
INFO To ensure that the cooktops perform optimally
at all times, there must be sufficient ventilation
beneath the cooktops.
INFO The performance of the cooktops is affected or
the cooktops overheat if the warm air beneath the
cooktops cannot escape.
INFO If a cooktop overheats, the power is automatically
reduced or the cooktop is switched off completely
(see Overheating protection).
INFO If cable protection (false floor) is planned beneath
the appliance, this must be fitted so it does not
obstruct ventilation.
Make sure that the area below the cooktop has a
sufficient air supply.
6.1.1 Simultaneous operation of the
cooktop extractor in the exhaust air
mode and a fireplace dependent upon
the air supply in the room
INFO The state and regional laws and regulations must
be observed with regard to the exhaust duct
design.
INFO A sufficient air supply must be ensured.
Fireplaces that depend on the air in the room (e.g. gas,
oil, wood or coal-fired heaters, continuous-flow water
heaters, instantaneous water heaters) draw in air from
the room in which they are installed and release the
exhaust fumes into the outside air via an exhaust system
(e.g. chimney).
If the cooktop extractor is used in exhaust mode, it draws
in air from the room in which it is installed as well as from
neighbouring rooms. If there is insufficient air supply, low
pressure will occur. Toxic gases could be drawn out of the
chimney or extraction ducting and back into the room.
Fig. 6.1 Exhaust air installation – not permitted
Fig. 6.2 Exhaust air installation – correct
If simultaneously operating both a fireplace and the
cooktop extractor in the same room, ensure that:
the maximum low pressure is 4 Pa (4 x 10–5 bar);
a safety device (e.g. window contact switch, low
pressure warning device) is used to ensure that a
sufficient supply of fresh air is guaranteed;
the exhaust air is not be ducted into a chimney that
is used for exhaust gases of devices operated with
gas or other combustibles;
the installation is checked and approved by an
authorised certified engineer (e.g. heating
engineer).
INFO If the cooktop extractor is used exclusively in
recirculation mode, operation with an open
fireplace is possible without any additional safety
measures.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bora Puru at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bora Puru in the language / languages: French as an attachment in your email.

The manual is 12,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bora Puru

Bora Puru User Manual - English - 60 pages

Bora Puru User Manual - German - 60 pages

Bora Puru User Manual - Dutch - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info