714404
25
Zoom out
Zoom in
Previous page
1/60
Next page
EN
25
Installation
www.bora.com
6.6 Installing the appliance in
exhaust air mode (PUXA, PURA)
i National and regional laws and regulations must be
observed with regard to the exhaust duct design.
i A sufficient air supply must be ensured.
i The exhaust air must be directed to the outside by
appropriate exhaust air ducts.
i The minimum cross-section of the air ducts must be
176 cm
2
, which equates to a round pipe with a diameter
of 150 mm or the BORA Ecotube duct system.
i As a general rule, with the built-in fan, a length of duct
of up to 6 metres with six 90° bends, 8 metres with four
90° bends or 10 metres with two 90° bends can be
installed.
i Not compatible with BORA Universal fans.
i Planning instructions for the installation of the exhaust
air ducts are provided in the BORA ventilation handbook.
6.6.1 Preparing kitchen units for the exhaust
air model
XO Cross bars on the kitchen unit in the area of the worktop cut-
out may need to be removed.
XO In the case of thin worktops, there must be a sufficiently rigid
support plate on the unit.
XO The back wall of the floor unit must be adapted for the
exhaust air duct.
XO A minimum clearance of 120 mm between the back wall of
the unit and an adjacent kitchen unit or room wall must be
observed for the air duct.
XO No false floor is necessary below the cooktop. If cable
protection (false floor) is planned, the following must be taken
into account:
XO It must be fitted in such a way that it can be removed
from below for maintenance work.
XO To ensure sufficient cooktop ventilation, a minimum
distance of 15 mm to the bottom edge of the cooktop is
to be observed.
XO The drawers and/or shelves in the floor unit must be
removable.
XO For correct installation, the drawers of the floor unit must be
shortened depending on the installation situation.
6.5.2 Pure cut-out dimensions (PURA, PURU)
Pure flush installation (PURA, PURU)
x
764 ±2
740 ±2
519 ±2
≤ R5
≤ R5
≥ 50
(≥ 50)
495 ±2
≥ 600
Fig. 6.11 Cut-out dimensions for ush installation
7 +0,5
12
10 - 40
Fig. 6.12 Rebate dimensions for ush installation
Pure surface mounting (PURA, PURU)
x
740 ±2
≤ R5
≥ 50 (≥ 50)
495 ±2
≥ 600
Fig. 6.13 Cut-out dimensions for surface mounting
10
10 - 40
Fig. 6.14 Overlay dimensions for surface mounting
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bora Pura at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bora Pura in the language / languages: English as an attachment in your email.

The manual is 12,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bora Pura

Bora Pura User Manual - German - 60 pages

Bora Pura User Manual - Dutch - 64 pages

Bora Pura User Manual - French - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info