714524
30
Zoom out
Zoom in
Previous page
1/44
Next page
EN
30
Operation
www.bora.com
7 Operation
Observe all safety and warning information during
operation (see Safety chapter).
INFO The integrated cooktop extractor must not be
used with other cooktops.
INFO The cooktop may only be operated when the
stainless steel grease filter and air inlet nozzle are
installed.
7.1 Switch on/off the cooktop and
cooking zone
Switching on
Press to switch on the cooktop.
The power level
0
is shown in the cooking zone
indicators.
Switching off
Press to switch off the cooktop.
Pay attention to the residual heat indicator
(see Chapter 6.1.7).
7.1.1 Switching on the cooking zone
Press the cooking zone button (e.g. ) for the
required cooking zone.
The
0
in the cooking zone indicator lights up more
brightly.
7.1.2 Adjusting the power level
INFO The configured power level lights up more brightly
and automatically darkens again after
a few seconds.
Press to adjust the power level
5
.
or
Press to adjust the power level
9
.
7.1.3 Changing the power level
Press the cooking zone button (e.g. ) of the desired
cooking zone. The cooking zone indicator lights up
more brightly.
Press or until the required power level is shown
in the cooking zone indicator.
7.1.4 Switching on the power setting
INFO The front left-hand cooking zone is equipped with
a performance-boosting power level.
Press the cooking zone button .
Continue pressing the until the power level
9
is
displayed in the cooking zone indicator.
Press again. The power level P is shown in the
cooking zone indicator.
After 30 minutes, the cooking zone is automatically
switched to power level
9
.
If one cooking zone is operated with the
P
power
setting, then the operation of the second cooking zone
on this side is possible at a maximum of power level
5
.
If power level
5
is increased, the
P
power setting is
switched off.
7.1.5 Switching the power setting off early
Press the cooking zone button . The indicator will
appear brighter.
Continue pressing until the lower power level you
want is displayed in the cooking zone indicator.
7.1.6 Switching off the cooking zone
Press the cooking zone button (e.g. ) of the desired
cooking zone.
Continue pressing or until the cooking zone
indicator indicates the power level
0
.
A
0
appears in the display for a few seconds.
7.1.7 Pay attention to the residual
heat display
After switching it off, the cooking zone remains hot.
H
is displayed in the cooking zone indicator (residual heat
indicator). This cooking zone indicator will also go out
after sufficient time is left to cool down (temperature
< 60 °C).
INFO While a
H
is indicated in the cooking zone
indicator (residual heat display), do not touch the
cooking zone and no not place any heat-sensitive
objects on top of it. Risk of burns and fire!
Pay attention to the residual heat indicator.
Make sure the hot hobs are not touched and no
objects are placed on it.
7.1.8 Using the automatic pre-cook valve
INFO When the automatic pre-cook valve is enabled,
the cooking zone will heat up automatically
at the highest level (heating impulse) before
switching back to the set power level (continuous
cooking level). The heating time depends on the
continuous cooking level
that is set (see Table 6.1).
INFO For high continuous cooking levels, only relatively
low heating times are needed. Usually, when
using these settings, empty cookware is heated
up in preparation for frying.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bora BHA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bora BHA in the language / languages: English as an attachment in your email.

The manual is 7,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bora BHA

Bora BHA User Manual - German - 44 pages

Bora BHA User Manual - Dutch - 44 pages

Bora BHA User Manual - French - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info