775461
14
Zoom out
Zoom in
Previous page
1/55
Next page
12
12
Figure 20. Pairing Sensors.
Force Pair
If the NODE fails to Pair with a sensor, or you add a sensor after the initial setup,
you can force the Pairing process:
1. In Ride mode, hold s1 and s2 for three seconds and then make each sensor
send a signal.
The display during Pairing
During the Pairing process, the display shows PAIRING SENSORS and the
receiving icon flashes in the lower right corner (Figure 20). When the computer
finds the signal and pairs to it, the icon for the sensor flashes three times and it
is then added to the display. Figure 21 shows the speed sensor is paired. The
Pairing process continues for one minute, or until you press any button to end it.
The display then shows SENSORS FOUND and a number, which is the number
of sensors to which it has paired.
When the pairing process is finished, the display shows SETUP COMPLETE
(Figure 22). Press the upper side button, s1, and then the computer shows the
DIST display and is in Ride Mode, ready for you to ride (Figure 23).
When the NODE changes to Ride mode and shows the Speed display,
it is ready for use.
If the speed icon does not appear after the Pairing process,
do one of the following:
•PerformtheForcePairprocedure
•PresstheResetbuttontostartover(eraseallsetup,seethecomplete
NODE manual)
•SeetheTroubleshootingsection.
s1 (3 seconds)
s2 (3 seconds)
Figure 21. Sensors Found. Figure 22. Setup Complete.
Figure 23. Ride Mode.
1.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bontrager Node at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bontrager Node in the language / languages: English as an attachment in your email.

The manual is 3.95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bontrager Node

Bontrager Node User Manual - English - 51 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info