Manual Bompani BO690 (page 17 of 60) (English, French, Italian, Spanish)

476989

Zoom out

Zoom in

1/60

CAUTION: The spit forks may have sharp points. Handle with

care.

OVEN LIGHT/ROTISSERIE SWITCH

- Gas cooker models are ﬁtted with a round switch;

- press this to turn on both the oven light and the rotisserie motor;

- gas-electric cookers (1 or 2 electric plates) are equipped with a

round switch with a red pilot light;

- this light comes on while 1 or 2 electric plates are in operation.

OPTIONAL MULTIPLE SPIT KIT

- Your rotisserie (which has 2 forks) can be equipped with an addi-

tional multiple spit mechanism.

- This can be ordered from your dealer at an additional charge.

FITTING THE MULTIPLE SPIT

- Remove the standard forks;

- place and secure the ﬂanges on the spit element as shown in ﬁgure

16;

- impale the foods on the spits;

- insert the spits on the ﬂanges as shown in ﬁgure 16;

- CAUTION: the two identical ﬂanges "A" must be placed at the

ends.

FOR COOKERS WITH MECHANICAL SPRING CLOCK ( ﬁg.17 )

The spring clock can be set for a maximum time of one hour by turning

the regulator knob clockwise to the time required. After the pre-set

time, a buzzer sounds and will stop automatically. When the buzzer

sounds, the spring clock does not cut out operation of the oven.

USE OF THE ELECTRONIC TIMER (ﬁg. 18)

This allows the start time and cooking duration time to be programmed.

If food does not need to be watched, this timer can be selected even

when the user is absent. Soon after installation and at any electrical

supply cut-outs the display ﬂashes; the clock must then be synchro-

nized again to allow programming.

SETTING THE TIMER TO THE CURRENT TIME

- The current time is set by pressing the 2 buttons (COOKING TIME

and STOP) and the "+" or "-" button at the same time. Any previous

programmes are cancelled and the AUTO symbol ﬂashes.

NOTE: when the AUTO symbol is ﬂashing the oven cannot be used

manually.

"+" AND "-" BUTTONS

- Pressing the "+" or "- "buttons makes time go up or down at variable

speed according to how long the button is pressed for.

MANUAL USE

- Press the MANUAL button: the AUTO symbol goes out (if ﬂashing or

permanently on) the SAUCEPAN symbol lights up and the oven can

be used by adjusting the thermostat knob and the selector switch

according to the instructions given in the manual.

AUTOMATIC OPERATION WITH END OF COOKING AND DURA-

TION TIMERS

- Let’s use an example: it is 9:25 am; you want the oven to switch on

at 11 am and switch off at 12 pm (cooking time 1 hour).

- Press the COOKING DURATION button and within 5 seconds press "+"

button until it shows 01.00, adjust using "-" button if necessary. The

AUTO and PAN symbols come on permanently.

- Press the END OF COOKING button and within 5 seconds press "+"

button until it shows 12.00. The PAN symbol goes out but the AUTO

symbol remains permanently on.

- Move the oven thermostat knob to the desired temperature, and the

selector switch to the required cooking method; the red warning light

comes on the oven light comes on and the timer is ready to start: at

11am the oven will come on automatically and the PAN symbol will

light up.

- When cooking is over (12 am) the AUTO symbol ﬂashes, the PAN

symbol goes out and a buzzer sounds; to turn off the buzzer press

any button.

- Move the thermostat and selector knob to the OFF position.

SEMI-AUTOMATIC OPERATION WITH COOKING DURATION

SELECTION

- Let’s take an example: it is 11:35 am and you want the oven to stay

on for 25 minutes from now on.

- Press the

COOKING DURATION button and within 5 seconds press the

"+" button until it shows 00.25, adjusting the time with the "-" button

if necessary. The

AUTO and PAN symbols light up permanently.

- Turn the oven thermostat knob to the desired temperature and the

selector switch to the required cooking method; the red warning light

comes on, the oven light comes on and the oven starts to operate.

- After 25 minutes the oven and the PAN symbol go out. The AUTO

symbol ﬂashes and the buzzer tells you that cooking is over: to turn

off the buzzer press any button.

- Then move the oven thermostat knob and the selector switch to the

OFF position.

MINUTE MINDER

- Press the MINUTE MINDER button and choose the desired time using

the "+" or "-" button.

- The BELL symbol lights up when the minute minder is in use.

- When the pre-set time is over, the buzzer sounds and the

BELL

symbol goes out.

BUZZER

- The buzzer sounds at the end of a programme and lasts for a maxi-

mum of 7 minutes.

- To turn it off, press any button.

- Pressing the "-" button without having previously selected a function

the frequency of the signal changes. A selection from 3 possibilities

can be made. The selected signal is audible as long as the "-" button

is pressed.

STARTING AND CHECKING A PROGRAMME

- The programme starts after about 4 seconds of it being set.

- The set programme can be checked at any point by pushing the

corresponding buttons.

PROGRAMMING ERRORS

- Example: at 12:15 pm a COOKING DURATION time of 30 minutes

is set and a END OF COOKING is programmed in at 12:30 pm.

- The programme error can be rectiﬁed by changing the duration or

the end of cooking time, or by pressing the MANUAL button and

programming again.

- If there is a programming error the oven will not come on.

ANNULLING A PROGRAMME

- A programme can be cancelled by pressing the COOKING DURA-

TION button and then the "-" button until the display shows 0.00.

IMPORTANT:AT THE END OF EVERY PROGRAMMED COOKING

OPERATION YOU ARE ADVISED TO PRESS THE

BUTTON,

OTHERWISE THE OVEN CANNOT BE OPERATED MANUALLY.

HOW TO USE OVEN ACCESSORIES

- The oven shelf is designed to take normal oven dishes for cook-

ing sweets or roasts, or is used without a pan for cooking foods

under the grill.

- The drip pan under the grill is used to collect juices, which drip

from the food that is cooked directly on the grill. The drip pan can

also be used for cooking

- Remember that cooking times may vary if food is cooked on two

shelves at the same time.

HOW TO USE THE CERAMIC HOB

The hotplate power has a sequential control device which ensures

excellent control of the cooking temperature.

The heat settings are from 1 to 6. The knob can be set in the re-

quired position by turning it to right or left.

On dual circuit plates, the knob only turns clockwise and the heat

settings are from 1 to 6, for the central zones of the plates only.

If the knob is turned forward another notch after the last heat set-

ting, the other zones of the plates will switch on.

For the user

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bompani BO690 in the language / languages: English, French, Italian, Spanish as an attachment in your email.

The manual is 1,77 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bompani BO690 Manual

Product: