Manual Bompani BO247 (page 18 of 28) (English, Dutch, French, Italian)

476972

Zoom out

Zoom in

1/28

For the userGB

- Move the oven thermostat knob to the desired temperature,

and the selector switch to the required cooking method; the

red warning light comes on the oven light comes on and the timer is

ready to start: at 11am the oven will come on automatically and the

PAN symbol will light up.

- When cooking is over (12 am) the AUTO symbol flashes, the PAN

symbol goes out and a buzzer sounds; to turn off the buzzer press

any button.

- Move the thermostat and selector knob to the OFF position.

SEMI-AUTOMATIC OPERATION WITH COOKING DURATION

SELECTION

- Let’s take an example: it is 11:35 am and you want the oven to stay

on for 25 minutes from now on.

- Press the COOKING DURATION button and within 5 seconds press

the "+" button until it shows 00.25, adjusting the time with the "-"

button if necessary. The AUTO and PAN symbols light up

permanently.

- Turn the oven thermostat knob to the desired temperature and the

selector switch to the required cooking method; the red warning light

comes on, the oven light comes on and the oven starts to operate.

- After 25 minutes the oven and the PAN symbol go out. The AUTO

symbol flashes and the buzzer tells you that cooking is over: to turn

off the buzzer press any button.

- Then move the oven thermostat knob and the selector switch to the

OFF position.

MINUTE MINDER

- Press the MINUTE MINDER button and choose the desired time

using the "+" or "-" button.

- The BELL symbol lights up when the minute minder is in use.

- When the pre-set time is over, the buzzer sounds and the BELL

symbol goes out.

BUZZER

- The buzzer sounds at the end of a programme and lasts for a

maximum of 7 minutes.

- To turn it off, press any button.

- Pressing the "-" button without having previously selected a function

the frequency of the signal changes. A selection from 3 possibilities

can be made. The selected signal is audible as long as the "-" button

is pressed.

STARTING AND CHECKING A PROGRAMME

- The programme starts after about 4 seconds of it being set.

- The set programme can be checked at any point by pushing the

corresponding buttons.

PROGRAMMING ERRORS

- Example: at 12:15 pm a COOKING DURATION time of 30 minutes

is set and a END OF COOKING is programmed in at 12:30 pm.

- The programme error can be rectified by changing the duration or

the end of cooking time, or by pressing the MANUAL button and

programming again.

- If there is a programming error the oven will not come on.

ANNULLING A PROGRAMME

- A programme can be cancelled by pressing the COOKING

DURATION button and then the "-" button until the display shows

0.00.

IMPORTANT:

AT THE END OF EVERY PROGRAMMED COOKING OPERATION

YOU ARE ADVISED TO PRESS THE BUTTON, OTHERWISE

THE OVEN CANNOT BE OPERATED MANUALLY.

USE OF “RUSTIC OVEN” TIMER / USE OF END OF COOKING

TIMER(fig. 8)

This allows the user to set the cooking duration.

SETTING THE CLOCK

Press the knob (A) and turn it anti-clockwise until the correct time is

reached.

SETTING THE COOKING END TIME

Turn the knob (A) anti-clockwise, without pushing, until the pointer is

on the desired cooking time (max. 90 min). At the end of the preset

time, the oven switches off and a buzzer sounds. To stop the buzzer,

turn the knob (A) anti-clockwise until the pointer is in line with the

symbol.

N.B. To use the oven in manual mode (without the aid of the timer) it

is essential to turn the pointer to the symbol.

CLEANING THE OVEN

- The oven should be cleaned after each use, when it is still lukewarm

but not hot. This allows fats to be removed before they have time to

dry.

- If stubborn stains remain place a cloth soaked in ammonia on the

bottom of the oven, close the door and leave for a few hours. Then

wash the oven with hot water and liquid detergent and dry completely.

- For the outside of the oven, use a soft cloth and soapy water.

NEVER USE POWDER DETERGENTS OR OTHER ABRASIVE

PRODUCTS.

FOR COOKERS WITH SELF-CLEANING OVEN

The two side walls and the back are coated with a catalytic self-cleaning

enamel.

Every 10-15 times it is used, leave the oven empty at full heat. The

time required for cleaning depends on the condition of the oven. Some

splashes tend to set hard and may clog the pores of the special coating,

preventing oxidation and eliminating its self-cleaning properties. In

this case, as soon as the oven has completely cooled apply very hot

water to soften the deposits and use a soft brush, without detergent,

to remove them. Then switch the oven back on at maximum heat for

a few minutes.

(Important: never use metal brushes or abrasive substances).

CHANGING THE OVEN LIGHT BULB

- Switch the oven off and disconnect it from the mains electrical supply;

- the light bulb is in the top right-hand corner of the back of the oven;

- make sure that the oven is cold and unscrew the glass lamp-holder;

- replace the light bulb with another of the same type and screw the

lamp-holder back firmly into place.

REMOVING THE OVEN DOOR

The door can be removed for easier oven cleaning by proceeding as

follows:

1) Open the door completely;

2) press down the hook “B” and gently lift arm “A” (fig. 9);

3) lift the door, holding it at both sides and pull it forward (fig. 10);

4) to replace the door, return the hinges to their places making sure

they are fitted into their seats; it suffices instead to lower the door

completely;

5) release the door carefully until it reaches its closed position.

GENERAL PRECAUTIONS

- Always disconnect the power supply before any work inside the

oven or where live parts may be accessed.

- Any overheating of the outside walls of the oven will trip the safety

device, which will cut off the power supply. The power supply will be

restored automatically once the outside temperature of the oven

has dropped back within acceptable limits. However, remember

that if this device is tripped repeatedly, there is a malfunction (e.g.

breakage of the thermostat which regulates the temperature inside

the oven). Call in your service engineer.

- Never touch the door hinges accidentally; this may cause injury.

- When the oven and grill are switched on for the first time there may

be a typical smell and smoke may come out of the oven. This is

because of the treatment applied to the surfaces. Operate the oven

empty before placing foods inside.

- Some modeles are fitted an automatic cooling motor.

-The appliance is not intended for use by young children or

infirm persons without supervision.

-Young children should be supervised to ensure that they do

not play with the appliance.

-If the supply cord is damaged, it must be replaced by the

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bompani BO247 in the language / languages: English, Dutch, French, Italian as an attachment in your email.

The manual is 0,32 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bompani BO247 Manual

Product: